Define bindings for pwm-stm32

version 6:
- change st,breakinput parameter format to make it usuable on stm32f7 too.

version 2:
- use parameters instead of compatible of handle the hardware configuration

Signed-off-by: Benjamin Gaignard <redacted>
---
 .../devicetree/bindings/pwm/pwm-stm32.txt          | 33 ++++++++++++++++++++++
 1 file changed, 33 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/pwm/pwm-stm32.txt

diff --git a/Documentation/devicetree/bindings/pwm/pwm-stm32.txt b/Documentation/devicetree/bindings/pwm/pwm-stm32.txt
new file mode 100644
index 0000000..866f222
--- /dev/null
+++ b/Documentation/devicetree/bindings/pwm/pwm-stm32.txt

@@ -0,0 +1,33 @@
+STMicroelectronics STM32 Timers PWM bindings
+
+Must be a sub-node of an STM32 Timers device tree node.
+See ../mfd/stm32-timers.txt for details about the parent node.
+
+Required parameters:
+- compatible:		Must be "st,stm32-pwm".
+- pinctrl-names: 	Set to "default".
+- pinctrl-0: 		List of phandles pointing to pin configuration nodes for PWM module.
+			For Pinctrl properties see ../pinctrl/pinctrl-bindings.txt
+
+Optional parameters:
+- st,breakinput:	Arrays of three u32 <index level filter> to describe break input configurations.
+			"index" indicates on which break input the configuration should be applied.
+			"level" gives the active level (0=low or 1=high) for this configuration.
+			"filter" gives the filtering value to be applied.
+
+Example:
+	timers at 40010000 {