[PATCH v2 0/3] ARM: dts: imx6: Support Poslab Savageboard dual & quad

Hi Milo,

On Tue, Dec 6, 2016 at 5:08 AM, Milo Kim [off-list ref] wrote:

Poslab Savageboard is i.MX6 SoC base, but BSP code from the vendor is
not mainline u-boot and kernel. Personal reason of using this board is
testing etnaviv user-space driver, so I re-write device tree files based on
mainline kernel for the first step.

This patchset includes common DT file, dual and quad board files.

Supported components are
  - Display: HDMI and LVDS panel
  - eMMC and SD card
  - Ethernet
  - Pinmux configuration
  - SATA: only for Savageboard quad
  - UART1 for debug console
  - USB host

Missing features are
  - Audio (WM8903)
  - USB OTG
  - PMIC WM8326: default settings are used so no issue to bring-up the system
  - MIPI DSI, CSI

Patches are tested on the Savageboard quad but the dual version should work
because the only difference between dual and quad is SATA support.

More information in http://www.savageboard.org

v2:
  Fix DT node for regulator, phy-reset-gpios and iomuxc node.

Milo Kim (3):
  ARM: dts: imx6: Add Savageboard common file
  ARM: dts: imx6: Support Savageboard dual
  ARM: dts: imx6: Support Savageboard quad

 arch/arm/boot/dts/imx6dl-savageboard.dts   |  50 ++++++
 arch/arm/boot/dts/imx6q-savageboard.dts    |  54 ++++++
 arch/arm/boot/dts/imx6qdl-savageboard.dtsi | 262 +++++++++++++++++++++++++++++

You missed to add imx6q-savageboard.dtb and imx6dl-savageboard.dtb
entries into arch/arm/boot/dts/Makefile