On Monday, November 21, 2016 9:48:21 PM CET Florian Fainelli wrote:

This pull request contains Broadcom ARM64 based SoC Device Tree changes for
4.10, please pull the following:

- Robin updates the Northstart 2 DTS to use the generic IOMMU binding

- Scott renames the Broadcom Northstar 2 binding document to use a standard name
  including the brcm vendor prefix

- Kamal adds the QSPI Device Tree node to the Northstar 2 SoC and updates the
  Northstar 2 SVK reference board DTS file with it enabled.

- Rob adds the Device Tree node for the Broadcom PDC (mailbox) hardware to the
  Northstar 2 SoC

- Jon enables the SDIO1 block and adds proper PCIe PHYs Device Tree nodes to the
  Northstar 2 SoC

- Ray adds required properties NAND controller properties to make NAND work on
  the Northstar 2 SVK board, this was submitted as a 4.9 fixes and is included
  here to resolve DTS file merges

- Andrea removes an incorrect power LED from the Raspberry Pi 3 DTS

- Andreas fixes the compatible string for the BCM2837 (Raspberry Pi 3)

- Eric defines standard pinctrl groups in the BCM2835 GPIO node

- Gerd adds definitions for the pinctrl groups and updates the PWM, I2C and SDHCI nodes
  to use their appropriate pinctrl functions

- Linus adds names for the Raspberry Pi GPIO lines based on the datasheet

- Martin adds the DT binding and nodes for the Raspberry Pi firmware thermal block

- Stefan fixes a few typos with respect to the BCM2835 mailbox binding example and
  Device Tree nodes he also uses the proper DTSI file to define the USB host mode
  for the USB Device Tree nodes

Pulled into next/dt64, thanks!

	Arnd