[RFC v2: PATCH 1/2] dt-bindings: Document the hi3660 reset bindings

On 2016?11?24? 17:26, Philipp Zabel wrote:

Am Mittwoch, den 23.11.2016, 16:07 +0800 schrieb Zhangfei Gao:

quoted

Add DT bindings documentation for hi3660 SoC reset controller.

Signed-off-by: Zhangfei Gao <zhangfei.gao@linaro.org>
---
  .../bindings/reset/hisilicon,hi3660-reset.txt      | 51 ++++++++++++++++++++++
  1 file changed, 51 insertions(+)
  create mode 100644 Documentation/devicetree/bindings/reset/hisilicon,hi3660-reset.txt

diff --git a/Documentation/devicetree/bindings/reset/hisilicon,hi3660-reset.txt b/Documentation/devicetree/bindings/reset/hisilicon,hi3660-reset.txt
new file mode 100644
index 0000000..250daf2
--- /dev/null
+++ b/Documentation/devicetree/bindings/reset/hisilicon,hi3660-reset.txt

@@ -0,0 +1,51 @@
+Hisilicon System Reset Controller
+======================================
+
+Please also refer to reset.txt in this directory for common reset
+controller binding usage.
+
+The reset controller registers are part of the system-ctl block on
+hi3660 SoC.
+
+Required properties:
+- compatible: should be
+		 "hisilicon,hi3660-reset"
+- #reset-cells: 1, see below
+- hisi,rst-syscon: phandle of the reset's syscon.
+- hisi,reset-bits: Contains the reset control register information
+		  Should contain 2 cells for each reset exposed to
+		  consumers, defined as:
+			Cell #1 : offset from the syscon register base
+			Cell #2 : bits position of the control register
+
+Example:
+	iomcu: iomcu at ffd7e000 {
+		compatible = "hisilicon,hi3660-iomcu", "syscon";
+		reg = <0x0 0xffd7e000 0x0 0x1000>;
+	};
+
+	iomcu_rst: iomcu_rst_controller {

This should be
	iomcu_rst: reset-controller {

By the way, could I keep the original name?
Since there will be build error if several nodes use the same name.
like:
-               iomcu_rst: iomcu_rst_controller {
+               iomcu_rst: reset-controller {

-               crg_rst: crg_rst_controller {
+               crg_rst: reset-controller {

Thanks