[PATCH v3 1/3] pinctrl: sunxi: Fix PIN_CONFIG_BIAS_PULL_{DOWN, UP} argument
From: Chen-Yu Tsai <hidden>
Date: 2016-11-11 09:50:46
Also in:
linux-gpio, lkml
Subsystem:
arm/allwinner sunxi soc support, pin control subsystem, the rest · Maintainers:
Chen-Yu Tsai, Jernej Skrabec, Samuel Holland, Linus Walleij, Linus Torvalds
According to pinconf-generic.h, the argument for
PIN_CONFIG_BIAS_PULL_{DOWN,UP} is non-zero if the bias is enabled
with a pull up/down resistor, zero if it is directly connected
to VDD or ground.
Since Allwinner hardware uses a weak pull resistor internally,
the argument should be 1.
Signed-off-by: Chen-Yu Tsai <redacted>
Acked-by: Maxime Ripard <redacted>
---
drivers/pinctrl/sunxi/pinctrl-sunxi.c | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)
diff --git a/drivers/pinctrl/sunxi/pinctrl-sunxi.c b/drivers/pinctrl/sunxi/pinctrl-sunxi.c
index e199d95af8c0..e04edda8629d 100644
--- a/drivers/pinctrl/sunxi/pinctrl-sunxi.c
+++ b/drivers/pinctrl/sunxi/pinctrl-sunxi.c@@ -291,12 +291,16 @@ static unsigned long *sunxi_pctrl_build_pin_config(struct device_node *node, if (sunxi_pctrl_has_bias_prop(node)) { int pull = sunxi_pctrl_parse_bias_prop(node); + int arg = 0; if (pull < 0) { ret = pull; goto err_free; } - pinconfig[idx++] = pinconf_to_config_packed(pull, 0); + if (pull != PIN_CONFIG_BIAS_DISABLE) + arg = 1; /* hardware uses weak pull resistors */ + + pinconfig[idx++] = pinconf_to_config_packed(pull, arg); }
--
2.10.2