Am Freitag, den 21.10.2016, 17:45 +0200 schrieb Philipp Zabel:

     A. Hi Geert,

Am Freitag, den 21.10.2016, 15:17 +0200 schrieb Geert Uytterhoeven:

quoted

        Hi Philipp, Mike, Stephen, Simon, Magnus,
	(see questions *** below!)

Currently the R-Car Clock Pulse Generator (CPG) drivers obtains the
state of the mode pins either by a call from the platform code, or
directly by using a hardcoded register access. This is a bit messy, and
creates a dependency between driver and platform code.

This patch series converts the various Renesas R-Car clock drivers
and support code from reading the mode pin states using a hardcoded
register access to using a new minimalistic R-Car RST driver.

All R-Car clock drivers will rely on the presence in DT of a device node
for the RST module.  Backwards compatibility with old DTBs is retained
only for R-Car Gen2, which has fallback code using its own private copy
of rcar_gen2_read_mode_pins().

I think you should add a binding doc even though the DT bindings are
still trivial.

Disregard that, I literally sent this mail and a second later noticed
patch 1 for the first time.

regards
Philipp