[PATCH v2 1/6] usb: dwc2: add support for Meson8b and GXBB SoCs

On 9/14/2016 9:11 AM, Kevin Hilman wrote:

Hi John,

Martin Blumenstingl [off-list ref] writes:

quoted

From: Jerome Brunet <jbrunet@baylibre.com>

Add compatible strings for amlogic Meson8b and GXBB SoCs with the
corresponding configuration parameters.

Signed-off-by: Jerome Brunet <jbrunet@baylibre.com>
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>

Are you OK with adding this platform for v4.9?  I know you mentioned
you're working on new bindings to replace the current way, but since
that hasn't been posted AFAICT, it would be nice to get this merged now
and we can help test the new bindings when you're ready.

If you're OK with that, and with your Ack, I can take merge the driver
changes through the arm-soc tree along with the rest of the DT patches.

Sure. Unfortunately, I wasn't able to complete it for 4.9.

You can add my acked-by on this:

Acked-by: John Youn <redacted>

Regards,
John

Kevin

quoted

---
 Documentation/devicetree/bindings/usb/dwc2.txt |  2 ++
 drivers/usb/dwc2/platform.c                    | 34 ++++++++++++++++++++++++++
 2 files changed, 36 insertions(+)

diff --git a/Documentation/devicetree/bindings/usb/dwc2.txt b/Documentation/devicetree/bindings/usb/dwc2.txt
index 20a68bf..2c30a54 100644
--- a/Documentation/devicetree/bindings/usb/dwc2.txt
+++ b/Documentation/devicetree/bindings/usb/dwc2.txt

@@ -10,6 +10,8 @@ Required properties:
   - "rockchip,rk3288-usb", "rockchip,rk3066-usb", "snps,dwc2": for rk3288 Soc;
   - "lantiq,arx100-usb": The DWC2 USB controller instance in Lantiq ARX SoCs;
   - "lantiq,xrx200-usb": The DWC2 USB controller instance in Lantiq XRX SoCs;
+  - "amlogic,meson8b-usb": The DWC2 USB controller instance in Amlogic Meson8b SoCs;
+  - "amlogic,meson-gxbb-usb": The DWC2 USB controller instance in Amlogic S905 SoCs;
   - snps,dwc2: A generic DWC2 USB controller with default parameters.
 - reg : Should contain 1 register range (address and length)
 - interrupts : Should contain 1 interrupt

diff --git a/drivers/usb/dwc2/platform.c b/drivers/usb/dwc2/platform.c
index fc6f525..8f7b34c 100644
--- a/drivers/usb/dwc2/platform.c
+++ b/drivers/usb/dwc2/platform.c

@@ -181,6 +181,38 @@ static const struct dwc2_core_params params_ltq = {
 	.hibernation			= -1,
 };
 
+static const struct dwc2_core_params params_amlogic = {
+	.otg_cap			= DWC2_CAP_PARAM_NO_HNP_SRP_CAPABLE,
+	.otg_ver			= -1,
+	.dma_enable			= 1,
+	.dma_desc_enable		= 0,
+	.dma_desc_fs_enable		= 0,
+	.speed				= DWC2_SPEED_PARAM_HIGH,
+	.enable_dynamic_fifo		= 1,
+	.en_multiple_tx_fifo		= -1,
+	.host_rx_fifo_size		= 512,
+	.host_nperio_tx_fifo_size	= 500,
+	.host_perio_tx_fifo_size	= 500,
+	.max_transfer_size		= -1,
+	.max_packet_count		= -1,
+	.host_channels			= 16,
+	.phy_type			= DWC2_PHY_TYPE_PARAM_UTMI,
+	.phy_utmi_width			= -1,
+	.phy_ulpi_ddr			= -1,
+	.phy_ulpi_ext_vbus		= -1,
+	.i2c_enable			= -1,
+	.ulpi_fs_ls			= -1,
+	.host_support_fs_ls_low_power	= -1,
+	.host_ls_low_power_phy_clk	= -1,
+	.ts_dline			= -1,
+	.reload_ctl			= 1,
+	.ahbcfg				= GAHBCFG_HBSTLEN_INCR8 <<
+					  GAHBCFG_HBSTLEN_SHIFT,
+	.uframe_sched			= 0,
+	.external_id_pin_ctl		= -1,
+	.hibernation			= -1,
+};
+
 /*
  * Check the dr_mode against the module configuration and hardware
  * capabilities.

@@ -464,6 +496,8 @@ static const struct of_device_id dwc2_of_match_table[] = {
 	{ .compatible = "lantiq,xrx200-usb", .data = &params_ltq },
 	{ .compatible = "snps,dwc2", .data = NULL },
 	{ .compatible = "samsung,s3c6400-hsotg", .data = NULL},
+	{ .compatible = "amlogic,meson8b-usb", .data = &params_amlogic },
+	{ .compatible = "amlogic,meson-gxbb-usb", .data = &params_amlogic },
 	{},
 };
 MODULE_DEVICE_TABLE(of, dwc2_of_match_table);