On Wed, Sep 28, 2016 at 01:30:17AM +0200, Maciej S. Szmigiero wrote:

On 20.09.2016 05:36, Peter Chen wrote:

quoted

Hi all,

This is a follow-up for my last power sequence framework patch set [1].
According to Rob Herring and Ulf Hansson's comments[2]. The kinds of
power sequence instances will be added at postcore_initcall, the match
criteria is compatible string first, if the compatible string is not
matched between dts and library, it will try to use generic power sequence.
	 
The host driver just needs to call of_pwrseq_on/of_pwrseq_off
if only one power sequence instance is needed, for more power sequences
are used, using of_pwrseq_on_list/of_pwrseq_off_list instead (eg, USB hub driver).

In future, if there are special power sequence requirements, the special
power sequence library can be created.

This patch set is tested on i.mx6 sabresx evk using a dts change, I use
two hot-plug devices to simulate this use case, the related binding
change is updated at patch [1/6], The udoo board changes were tested
using my last power sequence patch set.[3]

Except for hard-wired MMC and USB devices, I find the USB ULPI PHY also
need to power on itself before it can be found by ULPI bus.

[1] http://www.spinics.net/lists/linux-usb/msg142755.html
[2] http://www.spinics.net/lists/linux-usb/msg143106.html
[3] http://www.spinics.net/lists/linux-usb/msg142815.html

Just tested this patch set on UDOO board again to make sure that it still
works after all changes done since it was last tested there and can confirm
that it does work correctly.

Thanks, Maciej.

-- 

Best Regards,
Peter Chen