[PATCH 1/2] ARM: dts: am57xx-beagle-x15: Remove pinmux configurations

On 09/02/2016 05:18 AM, Sekhar Nori wrote:

On Friday 02 September 2016 02:35 PM, Nishanth Menon wrote:

quoted

pinmuxing for DRA7x/AM57x family of processors need to be done in IO
isolation as part of initial bootloader executed from SRAM. This is
done as part of iodelay configuration sequence and is required due to
the limitations introduced by erratum ID: i869[1] and elaborated in
the Technical Reference Manual[2] 18.4.6.1.7 Isolation Requirements.

Only peripheral that is permitted for dynamic pin mux configuration is
MMC. This is to accommodate the requirements for varied speeds (which

Actually its MMC and DCAN. DCAN because of i893 ("DCAN Initialization
Sequence"). But I can see you may have omitted reference to it since
DCAN is not really used on the x15.

True, I should add that for completeness. will do. thanks for catching 
the same.


-- 
Regards,
Nishanth Menon