[PATCH v22 2/8] arm64: limit memory regions based on DT property, usable-memory-range

Hi Akashi,

Sorry for the late response, (I was on holiday last week...)

On 04/08/16 07:21, AKASHI Takahiro wrote:

On Mon, Jul 25, 2016 at 02:27:55PM +0900, AKASHI Takahiro wrote:

quoted

On Fri, Jul 22, 2016 at 02:55:02PM +0100, James Morse wrote:

quoted

On 21/07/16 01:57, AKASHI Takahiro wrote:

quoted

Could you please apply the diff attached below and confirm that
kdump works in your environment?
I can't test it by myself since my hikey board seems to be broken now.

With this I get a failure even earlier, even with 'acpi=off'.
With this patch, on boot of the kdump kernel I get:

I think you ran into the problem that I mentioned in:
http://lists.infradead.org/pipermail/linux-arm-kernel/2016-July/444500.html

You may want to
- apply the change stated above, or
  (Given that we don't know about the configuration of crash dump kernel,
  checking for CONFIG_ZONE_DMA doesn't make sense. Instead, we'd better
  always enforce ARCH_LOW_ADDRESS_LIMIT.)
- explicitly specify the start address (Y) below ARCH_LOW_ADDRESS_LIMIT
  at "crashkernel=X at Y"
Either would work.

Have these methods fixed your problem in the end?

The change you made in v23 to use ARCH_LOW_ADDRESS_LIMIT fixed the problem with
juno and acpi. I will retest it with v24 and using Seattle too...

Thanks,

James