While only Freescale Vybrid SoC has settings of GPIO capabilities done
by iomux controller, it is only a matter of GPIO controller driver
implementation for the rest of Freescale/NXP SoCs from iMX series.

As a practical example on GPIO request a pad function should be
switched to GPIO, but because this requires updates to all particular
iMX pinctrl drivers, for simplicity at the moment add only a proper
connection between shared pinctrl-imx and pinctrl/pinmux core, namely
.gpio_request_enable/.gpio_disable_free/.gpio_set_direction callbacks
should return success to a caller. This change allows to progress by
adding request/free callbacks into gpio-mxc.c driver.

Signed-off-by: Vladimir Zapolskiy <redacted>
---
 drivers/pinctrl/freescale/pinctrl-imx.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/pinctrl/freescale/pinctrl-imx.c b/drivers/pinctrl/freescale/pinctrl-imx.c
index 56fd88013850..47613201269a 100644
--- a/drivers/pinctrl/freescale/pinctrl-imx.c
+++ b/drivers/pinctrl/freescale/pinctrl-imx.c

@@ -315,7 +315,7 @@ static int imx_pmx_gpio_request_enable(struct pinctrl_dev *pctldev,
 
 	/* Currently implementation only for shared mux/conf register */
 	if (!(info->flags & SHARE_MUX_CONF_REG))
-		return -EINVAL;
+		return 0;
 
 	pin_reg = &info->pin_regs[offset];
 	if (pin_reg->mux_reg == -1)

@@ -380,7 +380,7 @@ static int imx_pmx_gpio_set_direction(struct pinctrl_dev *pctldev,
 	 * They are part of the shared mux/conf register.
 	 */
 	if (!(info->flags & SHARE_MUX_CONF_REG))
-		return -EINVAL;
+		return 0;
 
 	pin_reg = &info->pin_regs[offset];
 	if (pin_reg->mux_reg == -1)

-- 
2.8.1