[PATCH] ARM: dts: add PM8058 LEDs to the APQ8060 Dragonboard

On 08/18/2016 03:10 PM, Linus Walleij wrote:

On Wed, Aug 17, 2016 at 11:40 PM, Jacek Anaszewski
[off-list ref] wrote:

quoted

quoted

+                               led at 48 {
+                                       /*
+                                        * The keypad LED @0x48 is routed
to
+                                        * the sensor board where it is
+                                        * connected to an infrared LED
+                                        * SFH4650 (60mW, @850nm) next to
the
+                                        * ambient light and proximity
sensor
+                                        * Capella Microsystems CM3605.
+                                        */
+                                       compatible =
"qcom,pm8058-keypad-led";
+                                       reg = <0x48>;
+                                       label = "proximity0";

In DT bindings documentation it was changed to "pm8050:white:keypad" to
adhere to the LED class device naming convention. I assume that having
it in this form is an omission here.

Hm right. Given the usecase here, what do you say about naming
it:

"pm8058:infrared:proximitysensor"

Looks good.

-- 
Best regards,
Jacek Anaszewski