Thread (1 message) 1 message, 1 author, 2016-08-17

[PATCH V2 RFC 6/6] ARM: dts: bcm2835: Add Raspberry Pi Zero

From: Stefan Wahren <hidden>
Date: 2016-08-17 19:11:28
Also in: linux-devicetree

Hi,
John Youn [off-list ref] hat am 17. August 2016 um 00:07
geschrieben:


On 8/16/2016 12:58 PM, Stefan Wahren wrote:
quoted
Hi John,
...

like in host mode i took the default values in otg mode for the last two
here
(please refer to the logs). The BCM2835 datasheet isn't very helpful.

Do you have any suggestions for valid values or how to get them?
The same values used in host-only mode should work.

It seems that the reset values for host-mode aren't being read
correctly with dr_mode == otg. I suspect this is the core reset and
force-mode delay problem.

Can you try with this patch series to see if you get the proper
values?

http://marc.info/?l=linux-kernel&m=145921907525708

This series fixes known issues, but it also breaks at least one
platform and I haven't had time to look at it properly yet.
thanks. Yes, that seems to fix host fifo sizes for bcm2835. Here the log after
applying patch 2 - 4 and removing all DT FIFO parameters (patch 1 has already
been merged):

Linux raspberrypi 4.7.0-rc7-next-20160719+ #23 Wed Aug 17 18:15:24 UTC 2016
armv6l

[    2.290723] dwc2_lowlevel_hw_init()
[    2.298123] dwc2_lowlevel_hw_enable()
[    2.305451] dwc2_get_dr_mode()
[    2.365040] dwc2_get_hwparams()
[    2.371785] dwc2 20980000.usb: Core Release: 2.80a (snpsid=4f54280a)
[    2.371801] dwc2 20980000.usb: hwcfg1=00000000
[    2.371813] dwc2 20980000.usb: hwcfg2=228ddd50
[    2.371823] dwc2 20980000.usb: hwcfg3=0ff000e8
[    2.371833] dwc2 20980000.usb: hwcfg4=1ff00020
[    2.371843] dwc2 20980000.usb: grxfsiz=00001000
[    2.371853] dwc2 20980000.usb: Forcing mode to host
[    2.371869] dwc2 20980000.usb: gnptxfsiz=01001000
[    2.371880] dwc2 20980000.usb: hptxfsiz=02002000
[    2.371890] dwc2 20980000.usb: Forcing mode to device
[    2.423450] dwc2 20980000.usb: gnptxfsiz=00201000
[    2.423468] dwc2 20980000.usb: Detected values from hardware:
[    2.423480] dwc2 20980000.usb:   op_mode=0
[    2.423490] dwc2 20980000.usb:   arch=2
[    2.423500] dwc2 20980000.usb:   dma_desc_enable=0
[    2.423511] dwc2 20980000.usb:   power_optimized=0
[    2.423520] dwc2 20980000.usb:   i2c_enable=0
[    2.423530] dwc2 20980000.usb:   hs_phy_type=1
[    2.423540] dwc2 20980000.usb:   fs_phy_type=1
[    2.423550] dwc2 20980000.usb:   utmi_phy_data_width=0
[    2.423559] dwc2 20980000.usb:   num_dev_ep=7
[    2.423570] dwc2 20980000.usb:   num_dev_perio_in_ep=0
[    2.423579] dwc2 20980000.usb:   host_channels=8
[    2.423590] dwc2 20980000.usb:   max_transfer_size=524287
[    2.423601] dwc2 20980000.usb:   max_packet_count=1023
[    2.423611] dwc2 20980000.usb:   nperio_tx_q_depth=0x4
[    2.423621] dwc2 20980000.usb:   host_perio_tx_q_depth=0x4
[    2.423631] dwc2 20980000.usb:   dev_token_q_depth=0x8
[    2.423641] dwc2 20980000.usb:   enable_dynamic_fifo=1
[    2.423651] dwc2 20980000.usb:   en_multiple_tx_fifo=1
[    2.423661] dwc2 20980000.usb:   total_fifo_size=4080
[    2.423671] dwc2 20980000.usb:   host_rx_fifo_size=4096
[    2.423681] dwc2 20980000.usb:   host_nperio_tx_fifo_size=256
[    2.423691] dwc2 20980000.usb:   host_perio_tx_fifo_size=512
[    2.423699] dwc2 20980000.usb:
[    2.423709] dwc2 20980000.usb: dwc2_set_parameters()
[    2.423723] dwc2 20980000.usb: Setting dma_desc_fs_enable to 0
[    2.423748] dwc2 20980000.usb: Setting external_id_pin_ctl to 0
[    2.423760] dwc2 20980000.usb: Setting hibernation to 0
[    2.423777] dwc2_force_dr_mode()
[    2.430509] dwc2 20980000.usb: Clearing force mode bits
[    2.499028] dwc2_gadget_init()
[    2.505422] dwc2 20980000.usb: Specified GNPTXFDEP=1024 > 32
[    2.514502] dwc2 20980000.usb: EPs: 8, dedicated fifos, 4080 entries in SPRAM
[    2.542143] dwc2 20980000.usb: bound driver zero
[    2.550164] dwc2_hcd_init()
[    2.556602] dwc2 20980000.usb: DWC OTG Controller
[    2.564878] dwc2 20980000.usb: new USB bus registered, assigned bus number 1
[    2.575467] dwc2 20980000.usb: irq 33, io mem 0x00000000

# cat /sys/kernel/debug/20980000.usb/fifo
Non-periodic FIFOs:
RXFIFO: Size 4096
NPTXFIFO: Size 32, Start 0x00200000

Periodic TXFIFOs:
        DPTXFIFO 1: Size 512, Start 0x00001020
        DPTXFIFO 2: Size 512, Start 0x00001220
        DPTXFIFO 3: Size 512, Start 0x00001420
        DPTXFIFO 4: Size 512, Start 0x00001620
        DPTXFIFO 5: Size 512, Start 0x00001820
        DPTXFIFO 6: Size 768, Start 0x00001a20
        DPTXFIFO 7: Size 768, Start 0x00001d20
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help