Hi Lin,

I add just one comment to remove the blank line.

On 2016? 08? 17? 07:36, Lin Huang wrote:

base on dfi result, we do ddr frequency scaling, register
dmc driver to devfreq framework, and use simple-ondemand
policy.

Signed-off-by: Lin Huang <redacted>
Reviewed-by: Chanwoo Choi <cw00.choi@samsung.com>
---
Changes in v6:
- fix some nit suggest by Chanwoo Choi

Changes in v5:
- improve dmc driver suggest by Chanwoo Choi

Changes in v4:
- use arm_smccc_smc() function talk to bl31
- delete rockchip_dmc.c file and config
- delete dmc_notify
- adjust probe order

Changes in v3:
- operate dram setting through sip call
- imporve set rate flow

Changes in v2:
- None

Changes in v1:
- move dfi controller to event
- fix set voltage sequence when set rate fail
- change Kconfig type from tristate to bool
- move unuse EXPORT_SYMBOL_GPL()

 drivers/devfreq/Kconfig      |  11 +
 drivers/devfreq/Makefile     |   1 +
 drivers/devfreq/rk3399_dmc.c | 497 +++++++++++++++++++++++++++++++++++++++++++
 3 files changed, 509 insertions(+)
 create mode 100644 drivers/devfreq/rk3399_dmc.c

[snip]

+
+static int rk3399_dmcfreq_probe(struct platform_device *pdev)
+{
+	struct arm_smccc_res res;
+	struct device *dev = &pdev->dev;
+	struct device_node *np = pdev->dev.of_node;
+	struct rk3399_dmcfreq *data;
+	int ret, irq, index, size;
+	uint32_t *timing;
+	struct dev_pm_opp *opp;
+
+	irq = platform_get_irq(pdev, 0);
+	if (irq < 0) {
+		dev_err(&pdev->dev, "Cannot get the dmc interrupt resource\n");
+		return -EINVAL;
+	}
+	data = devm_kzalloc(dev, sizeof(struct rk3399_dmcfreq), GFP_KERNEL);
+	if (!data)
+		return -ENOMEM;
+
+	mutex_init(&data->lock);
+
+	data->vdd_center = devm_regulator_get(dev, "center");
+	if (IS_ERR(data->vdd_center)) {
+		dev_err(dev, "Cannot get the regulator \"center\"\n");
+		return PTR_ERR(data->vdd_center);
+	}
+
+	data->dmc_clk = devm_clk_get(dev, "dmc_clk");
+	if (IS_ERR(data->dmc_clk)) {
+		dev_err(dev, "Cannot get the clk dmc_clk\n");
+		return PTR_ERR(data->dmc_clk);
+	};
+
+	data->irq = irq;
+	ret = devm_request_irq(dev, irq, rk3399_dmc_irq, 0,
+			       dev_name(dev), data);
+	if (ret) {
+		dev_err(dev, "Failed to request dmc irq: %d\n", ret);
+		return ret;
+	}
+
+	

Remove the unneeded blank line.

[snip]

Regards,
Chanwoo Choi