[PATCH v4 17/17] dt-bindings: pwm: sti: Update DT bindings with recent changes
From: Lee Jones <hidden>
Date: 2016-08-16 09:36:01
Also in:
linux-devicetree, linux-pwm, lkml
Subsystem:
open firmware and flattened device tree bindings, pwm subsystem, the rest · Maintainers:
Rob Herring, Krzysztof Kozlowski, Conor Dooley, Uwe Kleine-König, Linus Torvalds
We're renaming the 'st,pwm-num-chan' binding to 'st,pwm-num-devs' to be more inline with the naming conventions of the subsystem. Where we used to treat each line as a channel, the PWM convention is to describe them as devices. The second documentation adaption entails adding support for PWM capture devices. A new clock is required as well as an IRQ line. We're also adding a new property similar to the one described above, but for capture channels. Typically, there will be less capture channels than PWM-out, since all channels have the latter capability, but only some have capture support. Signed-off-by: Lee Jones <redacted> --- Documentation/devicetree/bindings/pwm/pwm-st.txt | 8 +++++--- 1 file changed, 5 insertions(+), 3 deletions(-)
diff --git a/Documentation/devicetree/bindings/pwm/pwm-st.txt b/Documentation/devicetree/bindings/pwm/pwm-st.txt
index 84d2fb8..19fce77 100644
--- a/Documentation/devicetree/bindings/pwm/pwm-st.txt
+++ b/Documentation/devicetree/bindings/pwm/pwm-st.txt@@ -13,13 +13,14 @@ Required parameters: - pinctrl-0: List of phandles pointing to pin configuration nodes for PWM module. For Pinctrl properties, please refer to [1]. -- clock-names: Set to "pwm". +- clock-names: Valid entries are "pwm" and/or "capture". - clocks: phandle of the clock used by the PWM module. For Clk properties, please refer to [2]. +- interrupts: IRQ for the Capture device Optional properties: -- st,pwm-num-chan: Number of available channels. If not passed, the driver - will consider single channel by default. +- st,pwm-num-chan: Number of available PWM channels. Default is 0. +- st,capture-num-chan: Number of available Capture channels. Default is 0. [1] Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt [2] Documentation/devicetree/bindings/clock/clock-bindings.txt
@@ -38,4 +39,5 @@ pwm1: pwm at fe510000 { clocks = <&clk_sysin>; clock-names = "pwm"; st,pwm-num-chan = <4>; + st,capture-num-chan = <2>; };
--
2.9.0