Currently the davinci da8xx boards use the mach-davinci aemif code.
Instantiating an aemif node into the DT allows to use the ti-aemif
memory driver and is another step to better DT support.
Also it will allow to properly pass the emif timings via DT.

Signed-off-by: Karl Beldan <redacted>
---
 arch/arm/boot/dts/da850.dtsi | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/arch/arm/boot/dts/da850.dtsi b/arch/arm/boot/dts/da850.dtsi
index bc10e7e..f62928c 100644
--- a/arch/arm/boot/dts/da850.dtsi
+++ b/arch/arm/boot/dts/da850.dtsi

@@ -411,6 +411,16 @@
 			dma-names = "tx", "rx";
 		};
 	};
+	aemif: aemif at 68000000 {
+		compatible = "ti,da850-aemif";
+		#address-cells = <2>;
+		#size-cells = <1>;
+
+		reg = <0x68000000 0x00008000>;
+		ranges = <0 0 0x60000000 0x08000000
+			  1 0 0x68000000 0x00008000>;
+		status = "disabled";
+	};
 	nand_cs3 at 62000000 {
 		compatible = "ti,davinci-nand";
 		reg = <0x62000000 0x807ff