[PATCH v23 0/9] arm64: add kdump support

Hi,

On Tue, Jul 26, 2016 at 11:09 AM, AKASHI Takahiro
[off-list ref] wrote:

On Tue, Jul 26, 2016 at 04:56:51PM +0900, AKASHI Takahiro wrote:

quoted

This patch series adds kdump support on arm64.

To load a crash-dump kernel to the systems, a series of patches to
kexec-tools, which have not yet been merged upstream, are needed.
Please pick Geoff's kexec patches [1] and my kdump patches [2].

To examine vmcore (/proc/vmcore) on a crash-dump kernel, you can use
  - crash utility (coming v7.1.6 or later) [3]
    (Necessary patches have already been queued in the master.)

[1]  http://lists.infradead.org/pipermail/kexec/2016-July/016532.html
[2]  TBD

See my kexec-tools patches in:
http://lists.infradead.org/pipermail/kexec/2016-July/016642.html

I tired this patch series with mentioned Geoff's kexec patches and
your kdump patches, but unfortunately it doesn't work for me.

While I can successfully load and kexec the kernel ('kexec --load' +
'kexec -e'), same combination of kernel+ramdisk+dtb doesn't boot
if I do kdump combination ('kexec -p' + sysrq crash), there is no
any output after sysrq crash trace.
Unfortunately I don't have any debugger here for deep investigation
of this issue.

Also for some reason in case of 'load and kexec the kernel' it
takes 1-2 minutes to start booting after I do kexec -e, need to
investigate it further.

Which hardware do you use for validating your patches?

Also, could you please share exact commands you use for
kdump validation?

Best regaerds,
Ruslan