[PATCH] oxnas: select reset controller framework

On Wednesday, July 6, 2016 3:04:25 PM CEST Neil Armstrong wrote:

2016-07-06 14:48 GMT+02:00 Arnd Bergmann [off-list ref]:

quoted

For unknown reasons, we have to enable three symbols for a platform
to use a reset controller driver, otherwise we get a Kconfig
warning:

warning: (MACH_OX810SE) selects RESET_OXNAS which has unmet direct dependencies (RESET_CONTROLLER)

This selects the other two symbols for oxnas.

Signed-off-by: Arnd Bergmann <arnd@arndb.de>
---
 arch/arm/mach-oxnas/Kconfig | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm/mach-oxnas/Kconfig b/arch/arm/mach-oxnas/Kconfig
index 2dde0acf01fd..b6a36d660e6f 100644
--- a/arch/arm/mach-oxnas/Kconfig
+++ b/arch/arm/mach-oxnas/Kconfig

@@ -11,11 +11,13 @@ if ARCH_OXNAS

 config MACH_OX810SE
        bool "Support OX810SE Based Products"
+       select ARCH_HAS_RESET_CONTROLLER

This is strange since this is selected by CONFIG_ARCH_OXNAS !

You are right, this one is not needed.

quoted

        select ARM_TIMER_SP8
        select COMMON_CLK_OXNAS
        select CPU_ARM926T
        select MFD_SYSCON
        select PINCTRL_OXNAS
+       select RESET_CONTROLLER

Same here, it should be selected by ARCH_HAS_RESET_CONTROLLER

I actually did a patch at one point to kill off ARCH_HAS_RESET_CONTROLLER
completely, it's not really needed at all, but that is a larger rework
so (I think) I never submitted it.

	Arnd