[PATCHv3 1/7] EDAC, altera: Check parent status for Arria10 EDAC block
From: bp@alien8.de (Borislav Petkov)
Date: 2016-06-17 16:46:32
Also in:
linux-devicetree
On Mon, Jun 13, 2016 at 04:19:06PM -0500, tthayer at opensource.altera.com wrote:
quoted hunk
From: Thor Thayer <redacted> In preparation for the Arria10 ECC modules, check the status of the parent in the device tree to ensure the block is enabled. Skip if no parent phandle is set in the device tree. Signed-off-by: Thor Thayer <redacted> --- v2 No change v3 Move check into validate_parent_available(). --- drivers/edac/altera_edac.c | 17 +++++++++++++++++ 1 file changed, 17 insertions(+)diff --git a/drivers/edac/altera_edac.c b/drivers/edac/altera_edac.c index 6f5d586..926bcaf 100644 --- a/drivers/edac/altera_edac.c +++ b/drivers/edac/altera_edac.c@@ -1125,6 +1125,20 @@ static void altr_edac_a10_irq_handler(struct irq_desc *desc) chained_irq_exit(chip, desc); } +static int validate_parent_available(struct device_node *np) +{ + struct device_node *parent; + + /* Ensure parent device is enabled if parent node exists */ + parent = of_parse_phandle(np, "parent", 0); + if (parent && !of_device_is_available(parent)) { + of_node_put(parent); + return -ENODEV; + } + of_node_put(parent); + return 0; +}
How about this - it is a bit simpler:
static int validate_parent_available(struct device_node *np)
{
struct device_node *parent;
int ret = 0;
/* Ensure parent device is enabled if parent node exists */
parent = of_parse_phandle(np, "parent", 0);
if (parent && !of_device_is_available(parent))
ret = -ENODEV;
of_node_put(parent);
return ret;
}
?
--
Regards/Gruss,
Boris.
ECO tip #101: Trim your mails when you reply.