[RFC PATCH 1/3] watchdog: Add Meson GXBB Watchdog Driver

On 05/27/2016 01:25 AM, Neil Armstrong wrote:
[ ... ]

quoted

quoted

+    data->wdt_dev.max_hw_heartbeat_ms = GXBB_WDT_TCNT_SETUP_MASK;
+    data->wdt_dev.min_hw_heartbeat_ms = 1;

Does the device require a minimum time between heartbeats ?
Just asking, because you violate it yourself below.

If you want to set the minimum timeout, that would be min_timeout.

Ok, these values are not very clear actually.

Hmmm .. yes, reading the description again, it doesn't really describe well
what it is doing. Essentially, min_hw_heartbeat_ms is enforced by the watchdog
core, and should be used if a watchdog hardware can not tolerate short intervals
between heartbeats. min_timeout is the minimum timeout value configurable from
user space.

quoted

quoted

+    data->wdt_dev.timeout = DEFAULT_TIMEOUT;
+    watchdog_set_drvdata(&data->wdt_dev, data);
+
+    watchdog_init_timeout(&data->wdt_dev, DEFAULT_TIMEOUT, &pdev->dev);
+

DEFAULT_TIMEOUT is unnecessary here. Since the default timeout is already set,
it makes the call useless.

quoted

+    ret = watchdog_register_device(&data->wdt_dev);
+    if (ret)
+        return ret;
+
+    /* Setup with 1ms timebase */
+    writel(((clk_get_rate(data->clk) / 1000) & GXBB_WDT_CTRL_DIV_MASK) |
+        GXBB_WDT_CTRL_EE_RESET |
+        GXBB_WDT_CTRL_CLK_EN |
+        GXBB_WDT_CTRL_CLKDIV_EN,
+        data->reg_base + GXBB_WDT_CTRL_REG);
+    meson_gxbb_wdt_set_timeout(&data->wdt_dev, data->wdt_dev.timeout);

set_timeout already calls the ping function. Also, the functions should be called
prior to watchdog registration to avoid race conditions.

quoted

+    meson_gxbb_wdt_ping(&data->wdt_dev);

This is unusual. If the watchdog can be already running, it might make sense
to tell the core about it (set WDOG_HW_RUNNING in the status field), so it
can send heartbeats until user space opens the device.

Yes, since meson_gxbb_wdt_set_timeout() already ping, this is useless.

Not only that - if the watchdog _is_ already running at boot time, you should
really set WDOG_HW_RUNNING to let the watchdog core know. You status function
would come handy there.

	if (meson_gxbb_wdt_status(data))	// note the changed parameter
		set_bit(WDOG_HW_RUNNING, &data->wdt_dev.status);

Thanks,
Guenter