On Tuesday, May 10, 2016 02:08:45 PM Linus Walleij wrote:

On Sun, May 8, 2016 at 3:08 PM, Christian Lamparter
[off-list ref] wrote:

quoted

From: ?lvaro Fern?ndez Rojas <redacted>

This patch adds support for defining memory-mapped GPIOs which
are compatible with the existing gpio-mmio interface.

Overall very nice, just waiting for the next version.

K, will deliver. I noticed that you sent a mail in which you stated
that you applied the dt binding already. Can you update your devel
branch on git.kernel.org's linux-gpio? Then, I'll simply rebase my
series and sent the remaining two patches.
(unless you tell me otherwise).
 

quoted

The first user for this binding is "wd,mbl-gpio".

And that binding defines that we have a register named "dat".

Yeah, I had to remove all non wd related bits. But since this 
series was posted (over and over :D) on a public mailing-list
the original  "generic" linux-mmio binding is available for
everybody to perusal[0] and study. I think what we can make
would be something like a devicetree template out of it. This
way people can remove unused flags and regnames for their
compatible device tree binding. (But first: need to finish
that ppc-gpio.txt).

quoted

+       if (of_property_read_bool(dev->of_node, "no-output"))

And then this too.

Do we want these generic MMIO bindings (dat, no-output)
in a special document like
Documentation/devicetree/bindings/gpio/gpio-mmio.txt?

Going forward?

Ah, I was thinking about Documentation/gpio... Since there's no
way it would go in the devicetree/bindings without having a compatible?
(And there's technically none). As far as I know the problem here is not
that it would be impossible to do that (updating a .dts file is "easy"...),
but updating .dtb to a tiny flash-rom on the device might not be. So we
have to make every effort to preserve compatibility for those devices
(and old/incomplete/broken dtbs) as long as the device is supported.

About adding new device:
This will work in the following way: 
 1. new drives will need to supply their hardware-specific devicetree
    binding file to the dt maintainers (This "vendor,device.txt" file
    will be like the wd,mbl-gpio.txt - but modified for the hardware
    (this is where the template would be handy)

 2. Make a one-liner patch which adds a compatible string to
    gpio-mmio.c's bgpio_of_match table:

+	{ .compatible = "vendor,device", .data = bgpio_basic_mmio_parse_dt },

(Of course, not having parses for the "ngpio" property and the flags like
big-endian, reg-output-reg,set, unreadable-reg-dir, ... properties from
the get-go is sad, these can add back once a driver/binding needs it).

I think brcm63xx will be following shortly. So we can test the
procedure.

This patch set mainly deals with refactorings, but in the
long run we want to slim things down a bit and use standard
bindings I think.

Well, to do that, I think we need to collect enough devices to
make it a real "class" of devices first.

Regards,
Christian

[0] <https://lkml.org/lkml/2016/4/28/921>