[RFC v2 00/13] usb/mmc/power: Fix USB/LAN when TFTP booting

On Fri, May 06, 2016 at 08:12:24AM +0200, Krzysztof Kozlowski wrote:

On 05/06/2016 07:44 AM, Peter Chen wrote:

quoted

On Thu, May 05, 2016 at 05:42:40PM -0500, Rob Herring wrote:

quoted

On Thu, May 05, 2016 at 02:34:13PM +0200, Krzysztof Kozlowski wrote:

quoted

Hi,

This is a different, second try to fix usb3503+lan on Odroid U3 board
if it was initialized by bootloader (e.g. for TFTP boot).

First version:
http://www.spinics.net/lists/linux-usb/msg140042.html


Problem
=======
When Odroid U3 (usb3503 + smsc95xx + max77686) boots from network (TFTP),
the usb3503 and LAN smsc95xx do not show up in "lsusb". Hard-reset
is required, e.g. by suspend to RAM. The actual TFTP boot does
not have to happen. Just "usb start" from U-Boot is sufficient.

From the schematics, the regulator is a supply only to LAN, however
without toggling it off/on, the usb3503 hub won appear neither.


Solution
========
This is very similar to the MMC pwrseq behavior so the idea is to:
1. Move MMC pwrseq drivers to generic place,

You can do that, but I'm going to NAK any use of pwrseq bindings outside 
of MMC. I think it is the wrong way to do things. The DT should describe 
the devices. If they happen to be "simple" then the core can walk the 
tree and do any setup. For example, look for "reset-gpios" and toggle 
that GPIO. There is no need for a special node.

Oh, I am doing the same thing like this patch set doing.

Shame on me that I did not use Google before starting the work. I could
just extend your patchset. I think we can combine our efforts.

Sure :)

-- 

Best Regards,
Peter Chen