On Fri, Feb 26, 2016 at 08:31:00PM -0500, David Rivshin (Allworx) wrote:
On Fri, 29 Jan 2016 23:26:50 -0500
"David Rivshin (Allworx)" [off-list ref] wrote:
quoted
From: David Rivshin <redacted>
When using a short PWM period (approaching the min of 2/clk_rate),
pwm-omap-dmtimer does not produce accurate results. In the worst case a
requested period of 2/clk_rate would result in a real period of 4/clk_rate
instead. This is a series includes a fix for that problem, as well as
other related improvements, and is based on the current linux-pwm/for-next
tip.
I have tested on a Sitara AM335x platform, using a scope to verify the
output with a variety of periods and duty cycles. This includes a PWM
rate up clk_rate/2 with 50% duty cycle (e.g. generating fclk/2) with
both 32768Hz and 24MHz fclks. I do not have an OMAP4 board to test with,
although appropriate sections in the the reference manuals appear
substantially the same, so I believe the changes are equally correct
there.
Note that the OMAP4 TRMs do effectively state that the maximum PWM
rate is clk_rate/4, so at very fast PWM rates the behavior may not be
as reliable as I observed with Sitara. Although I suspect that it's
the same module and will also work, at least under some circumstances.
If anyone with OMAP4 hardware and a scope is so inclined, I would be
curious to know the results.
David Rivshin (4):
pwm: omap-dmtimer: fix inaccurate period/duty_cycle calculation
pwm: omap-dmtimer: add sanity checking for load and match values
pwm: omap-dmtimer: round load and match values rather than truncate
pwm: omap-dmtimer: add dev_dbg() message for effective period and duty
cycle
drivers/pwm/pwm-omap-dmtimer.c | 71 ++++++++++++++++++++++++++++++++----------
1 file changed, 55 insertions(+), 16 deletions(-)
Hi Thierry,
Gentle ping. It does not look like you've taken this series, and I
wanted to make sure you're not waiting on something from me. It would
be nice to get at least the first patch into 4.5, if possible.
I've applied patches 1 and 3, and I'm planning on sending out a pull
request for inclusion in v4.5-rc7 later on.
Patches 2 and 4 didn't seem ready/critical, so let's finish those up
for v4.6-rc1.
Thierry
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 819 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20160304/9075a63b/attachment.sig>