[PATCH v6 1/3] dt-bindings: add bindings for rk3399 clock controller

@@ -0,0 +1,68 @@
+* Rockchip RK3399 Clock and Reset Unit
+
+The RK3399 clock controller generates and supplies clock to various
+controllers within the SoC and also implements a reset controller for SoC
+peripherals.
+
+Required Properties:
+
+- compatible: PMU for CRU should be "rockchip,rk3399-pmucru"
+- compatible: CRU should be "rockchip,rk3399-cru"
+- reg: physical base address of the controller and length of memory mapped
+  region.
+- #clock-cells: should be 1.
+- #reset-cells: should be 1.
+
+Optional Properties:
+
+- rockchip,grf: phandle to the syscon managing the "general register files"
+  If missing, pll rates are not changeable, due to the missing pll lock status.
+
+Each clock is assigned an identifier and client nodes can use this identifier
+to specify the clock which they consume. All available clocks are defined as
+preprocessor macros in the dt-bindings/clock/rk3399-cru.h headers and can be
+used in device tree sources. Similar macros exist for the reset sources in
+these files.
+
+External clocks:
+
+There are several clocks that are generated outside the SoC. It is expected
+that they are defined using standard clock bindings with following
+clock-output-names:
+ - "xin24m" - crystal input - required,
+ - "xin32k" - rtc clock - optional,
+ - "clkin_gmac" - external GMAC clock - optional,
+ - "gmac_phy_rx_clk" - external GMAC RX clock - optional,
+ - "clkin_i2s" - external I2S clock - optional,
+ - "pclkin_cif" - external ISP clock - optional,
+ - "clk_usbphy0_480m" - output clock of the pll in the usbphy0
+ - "clk_usbphy1_480m" - output clock of the pll in the usbphy1
+
+Example: Clock controller node:
+
+	pmucru: pmu-clock-controller at ff750000 {
+		compatible = "rockchip,rk3399-pmucru";
+		reg = <0x0 0xff750000 0x0 0x1000>;
+		#clock-cells = <1>;
+		#reset-cells = <1>;
+	};
+
+	cru: clock-controller at ff760000 {
+		compatible = "rockchip,rk3399-cru";
+		reg = <0x0 0xff760000 0x0 0x1000>;
+		#clock-cells = <1>;
+		#reset-cells = <1>;
+	};
+
+Example: UART controller node that consumes the clock generated by the clock
+  controller:
+
+	uart0: serial at ff1a0000 {
+		compatible = "rockchip,rk3399-uart", "snps,dw-apb-uart";
+		reg = <0x0 0xff180000 0x0 0x100>;
+		clocks = <&cru SCLK_UART0>, <&cru PCLK_UART0>;
+		clock-names = "baudclk", "apb_pclk";
+		interrupts = <GIC_SPI 99 IRQ_TYPE_LEVEL_HIGH>;
+		reg-shift = <2>;
+		reg-io-width = <4>;
+	};