On 21 March 2016 at 01:47, Alexander Shishkin
[off-list ref] wrote:

Chunyan Zhang [off-list ref] writes:

quoted

From: Mathieu Poirier <mathieu.poirier@linaro.org>

Some architecture like ARM assign masterIDs at the HW design
phase.  Those are therefore unreachable to users, making masterID
management in the generic STM core irrelevant.

In this kind of configuration channels are shared between masters
rather than being allocated on a per master basis.

This patch adds a new 'mshared' flag to struct stm_data that tells the
core that this specific STM device doesn't need explicit masterID
management.

There are two kinds of 'masterIDs' that we're talking about here: the
ones that turn up in the STP stream and the ones that are accessible to
trace-side software (sw_start/sw_end). So in this case we want to
reflect the fact that there is no correlation between the two, because
hardware assigns STP channels dynamically based on the states of the
trace/execution environment. And although the trace side software can do
very little with this information, it does make sense to provide it.

The sw_start==sw_end situation, on the other hand, is a side effect of
the above and, as I said in one of the previous threads, may not even be
the case, or at least I don't see why it has to. And when it is the
case, I don't see the point in handling it differently from
sw_start<sw_end situation.

quoted

In the core sw_start/end of masterID are set to '1',
i.e there is only one masterID to deal with.

Why does this need to be done in the core and why '1'? IOW,
sw_{start,end} come straight from the driver, this new 'mshared' comes
straight from the driver, why do we need the core to modify the former
based on the latter?

The logic here was to account for drivers that only set the 'mshared'
flag.  One could (wrongly) assume that if mshared is set in the
driver, sw_{start,end} are don't need to be set.  That way errors are
caught quicker.  I'm fine with removing that part.

Other than the above, is there anything you'd like to see modified in
this patch, i.e how the mshared flag is used to modify the output in
sysFS/configFS?

Thanks,
Mathieu

quoted

Also this patch depends on [1], so that the number of masterID
is '1' too.

It's 7b3bb0e753 in Linus' tree, but I don't see the logical connection
in the statement above.

That statement should have appeared in the cover letter rather than
this patch's blurb - that way it applies cleanly.

Regards,
--
Alex