[PATCH v2 0/2] spi: bcm2835aux: auxiliary spi improvements

From: Stephan Olbrich <redacted>

This patch series has some improvements and fixes for the auxiliary spi.

since v1:
- the first two patches "fix bitmask defines" and "disable tx fifo empty irq"
  were picked up by Mark Brown and applied to his spi tree so I don't post
  them again.
- speed bits are now reset before setting the new speed in case the speed
  changes between transfers
- remove CPHA from master->mode_bits
- rename CPHA bit mask to RISING to make it more clear why things are done
  that way

1. set up spi-mode before asserting cs-gpio
 As Martin Sperl suggested this is done in the same way as in spi-bcm2835.c
 acace73df2c1913a526c1b41e4741a4a6704c863

2. fix CPOL/CPHA setting
 From what I've seen in the documentation [1] and seen on the scope this chip
 doesn't support modes with CPHA=1. With this patch spi mode 0 and 2 should
 work correctly whereas mode 1 and 3 are not supported. 
                                                                                                                                                                                                            
Stephan Olbrich (2):
  spi: bcm2835aux: set up spi-mode before asserting cs-gpio
  spi: bcm2835aux: fix CPOL/CPHA setting

 drivers/spi/spi-bcm2835aux.c | 66 +++++++++++++++++++++++++++++---------------
 1 file changed, 44 insertions(+), 22 deletions(-)

-- 
2.5.0