marvell_cesa fails to register on kirkwood (88F6282)

Hi,

JM [off-list ref] writes:

On Fri, Feb 5, 2016 at 10:04 PM, Arnaud Ebalard [off-list ref] wrote:

quoted

Hi,

quoted

I'll try and do the same now w/ CESA support compiled as module to see
what I get. I'll keep you posted.

root at mood:~# insmod /tmp/marvell-cesa.ko
[  573.897977] marvell-cesa f1030000.crypto: CESA device successfully registered

root at mood:~# uname -a
Linux mood 4.4.0.duov2 #2 Fri Feb 5 21:42:49 CET 2016 armv5tel GNU/Linux

root at mood:~# zcat /proc/config.gz | grep -i CESA
# CONFIG_CRYPTO_DEV_MV_CESA is not set
CONFIG_CRYPTO_DEV_MARVELL_CESA=m

Cheers,

a+

ps: my config is temporarily at http://natisbad.org/config-duov2-cesa

I've built a vanilla 4.4.1 kernel image without any debian-specific
patches but using the same oldconfig
(http://heap.ovh/files/config-4.4.1.vanilla).

# uname -a
Linux yukikaze 4.4.1.vanilla #1 Sat Feb 6 14:18:19 CET 2016 armv5tel GNU/Linux

# modprobe marvell_cesa allhwsupport=1

# dmesg | tail -n1
[  116.972828] marvell-cesa: probe of f1030000.crypto failed with error -12

The dtb hasn't changed:
# diff -s kirkwood-ts219-6282.dtb dtb-4.4.1.vanilla
Files kirkwood-ts219-6282.dtb and dtb-4.4.1.vanilla are identical

I am also attaching lsmod: http://heap.ovh/files/lsmod-vanilla-4.4.1
and full dmesg: http://heap.ovh/files/dmesg-vanilla-4.4.1

Perhaps I am missing something obvious? I suppose the next step would
be to build a minimal kernel based on the config for the duov2?

I must confess your problem is interesting ;-)

I did a diff between your .config and mine for the Duo v2 and then tried
to enable/disable the most promising options you had and the one I had
not but I cannot reproduce the what you get, i.e. marvell_cesa module
always loads as expectec. 

So, I also think the best path would be to use my Duo v2 file w/ your dtb
and run it on your device.

Last (unrelated) remark/question: looking at the .dts for your ts219, I
noticed one thing I am curious about:

        memory {
                device_type = "memory";
                reg = <0x00000000 0x20000000>;
        };

        ...

        ocp at f1000000 {
                pinctrl: pin-controller at 10000 {

                        pinctrl-0 = <&pmx_ram_size &pmx_board_id>;
                        pinctrl-names = "default";

                        pmx_ram_size: pmx-ram-size {
                                /* RAM: 0: 256 MB, 1: 512 MB */
                                marvell,pins = "mpp36";
                                marvell,function = "gpio";
                        };

It seems 512MB are declared for all TS219 devices but the level
available on mpp36 provides the real amount of RAM in the device.
Who/What is expected to do the adjustment on platform w/ only 256MB, if
any?

Cheers,

a+