[PATCH 00/11] clk: lpc32xx: add clock support for NXP LPC32xx

Hi Vladimir,

On Wed, 2016-02-10 at 02:19 +0200, Vladimir Zapolskiy wrote:

Hi Sylvain,

On 09.02.2016 23:01, Sylvain Lemieux wrote:

quoted

Vladimir Zapolskiy <vz@...> writes:

quoted

This changeset adds common clock framework driver for NXP LPC32xx
boards.

Just to let you know that we did some testing using this changeset;
I installed patches 4 to 7, 10 & 11 on top of 4.5-rc1.

I was able to run our software (SIC1 interrupt sources disable)
without any problem a custom LPC32xx board.

this is a known issue, and I hope it will be fixed in upstream in v4.6,
the required changes in irqchip and gpiochip drivers were sent for
review some time ago, a bit more work is needed to 

I also tested the irqchip patches you sent previously;
I will send a separate e-mail with the information.

Also 2-3 more clean-up changes in USB host and gadget drivers are done
locally (no more need to configure clocks out of the common clock
framework), but not yet submitted, will do it tomorrow.

quoted

We did not get any problem with the clock signals we are using.

Thank you for testing, I'm going to add your Tested-by tag (if you
don't mind) and submit a PR to ARM maintainers shortly.

You can go ahead for the tag; please use slemieux at tycoint.com

quoted

quoted

Vladimir Zapolskiy (11):
  dt-bindings: clock: add description of LPC32xx clock controller
  dt-bindings: clock: add description of LPC32xx USB clock controller
  dt-bindings: clock: add NXP LPC32xx clock list for consumers
  arm: dts: lpc32xx: add device nodes for external oscillators
  arm: dts: lpc32xx: add clock controller device node
  arm: dts: lpc32xx: add clock properties to device nodes
  arm: dts: lpc32xx: add USB clock controller
  clk: lpc18xx: add NXP specific common clock framework selection
  clk: lpc32xx: add common clock framework driver
  arm: lpc32xx: switch to common clock framework
  arm: dts: lpc32xx: remove clock frequency property from UART device
    nodes

With best wishes,
Vladimir