[PATCH v4 5/5] pinctrl: sunxi: Use pin number when calling sunxi_pmx_set

On Tue, Feb 9, 2016 at 3:58 PM, Krzysztof Adamski
[off-list ref] wrote:

sunxi_pmx_set accepts pin number and then calculates offset by
subtracting pin_base from it. sunxi_pinctrl_gpio_get, on the other hand,
gets offset so we have to convert it to pin number so we won't get
negative value in sunxi_pmx_set.

This was only used on A10 so far, where there is only one GPIO chip with
pin_base set to 0 so it didn't matter. However H3 also requires this
workaround but have two pinmux sections, triggering problem for PL port.

Signed-off-by: Krzysztof Adamski <redacted>
Acked-by: Chen-Yu Tsai <redacted>
Acked-by: Maxime Ripard <redacted>

OK applied this version that has Maxime's ACK.

Yours,
Linus Walleij