[PATCH 0/3] omap: hwmod: add default reset handling support

On Tue, 9 Feb 2016, Dave Gerlach wrote:

Sorry got held up by the discussion here [1], that regression affects
rmmod/re-insmod of wkup_m3_rproc as well. If I revert the guilty patch
5de85b9d57ab ("PM / runtime: Re-init runtime
PM states at probe error and driver unbind") and apply these three patches, on
initial probe of the wkup_m3_rproc and wkup_m3_ipc drivers in v4.5-rc3 I see:

[   15.593460] omap_hwmod: wkup_m3: _wait_target_disable failed

Which is triggered by the reset of the wkup_m3 from the wkup_m3_ipc driver
when booting the wkup_m3_rproc. Flow is:

1. wkup_m3_rproc probes and calls pm_runtime_get_sync, which calls hwmod
_enable but bails out because _are_all_hardreset_lines_asserted(oh) causes it
to return 0.

2. wkup_m3_ipc probes and calls rproc_boot, which triggers
omap_device_deassert_hardreset in order to let the wkup_m3 start.

The patches that Kishon posted shouldn't change the existing hardreset 
behavior for any IP block with HWMOD_CUSTOM_HARDRESET marked.  If the
behavior changes before and after that patch set, something isn't right.

It is inside the omap_device_deassert_hardreset ( and inside that,
omap_hwmod_deassert_hardreset) where I end up with the error message, but
after that rmmod/insmod of the module over and over again shows no additional
error messages (at least with the above mentioned PM patch reverted).

I no longer recall why we had the _are_all_hardreset_lines_asserted(oh) 
test in place.  But we might be able to drop it now that we have the 
HWMOD_CUSTOM_HARDRESET flag.
 

- Paul