[PATCH v3 2/6] drivers/cpufreq: implement init_cpu_capacity_default()
From: vincent.guittot@linaro.org (Vincent Guittot)
Date: 2016-02-04 12:03:31
Also in:
linux-devicetree, linux-pm, lkml
On 4 February 2016 at 10:36, Morten Rasmussen [off-list ref] wrote:
On Wed, Feb 03, 2016 at 10:04:37PM +0100, Vincent Guittot wrote:quoted
On 3 February 2016 at 12:59, Juri Lelli [off-list ref] wrote:
[snip]
quoted
quoted
diff --git a/drivers/cpufreq/Makefile b/drivers/cpufreq/Makefile index 9e63fb1..c4025fd 100644 --- a/drivers/cpufreq/Makefile +++ b/drivers/cpufreq/Makefile@@ -1,5 +1,5 @@ # CPUfreq core -obj-$(CONFIG_CPU_FREQ) += cpufreq.o freq_table.o +obj-$(CONFIG_CPU_FREQ) += cpufreq.o freq_table.o cpufreq_capacity.oDo you really want to have the calibration of capacity dependent of cpufreq ? It means that we can't use it without a cpufreq driver. IMHO, this creates a unnecessary dependency. I understand that you must ensure that core runs at max fequency if a driver is present but you should be able to calibrate the capacity if cpufreq is not available but you have different capacity because micro architectureWe could remove the dependency on cpufreq, but it would make things more complicated for systems which do have frequency scaling as we would have to either: 1) Run the calibration again once cpufreq has been initialized.
or wait and let time for a driver to initialize and trig the calibration. If calibration has not been done at the end of the boot, you can force a calibration. If the cpufeq driver is a module and is loaded far later for any good or bad reason, we will have to run the calibration once again but at least the capacity will reflect he current capacity of the CPUs. I'm mainly worried that the compilation of the calibration is dependent of CONFIG_CPU_FREQ not that cpufreq can trig the calibration sequence
2) Know the frequency of all cpus at calibration time so we can determine the correct micro-archicture difference. This option would however mean that we have to provide a frequency scaling factor even for systems that don't have cpufreq. 3) Find a way to do the calibration anyway if cpufreq doesn't initialize. I'm not sure how that would work though.