imxfb does not turn on automatically

2015-02-21 16:18 GMT+01:00 Fabio Estevam [off-list ref]:

Hi,

Carlos Soto uses a Karo mx25 and he noticed that the LCD only works if we do:

echo 1 > /sys/class/graphics/fb0/blank
echo 0 > /sys/class/graphics/fb0/blank

I can confirm the same on mx25pdk running 3.19 [1], but I could not
understand why the display does not start turned on by default.

[1] http://www.spinics.net/lists/arm-kernel/msg399949.html

Any ideas?

Thanks,

Fabio Estevam

Hi,
I know it's been a long time since Fabio posted the issue but recently
I had some time to work on it again, and I've narrowed it down a
little.

The problem seems to be related to the IPG clock used by the iMX25
framebuffer. All clocks used by the fb are enabled in
imxfb_enable_controller(...)

...
clk_prepare_enable(fbi->clk_ipg);
clk_prepare_enable(fbi->clk_ahb);
clk_prepare_enable(fbi->clk_per);
fbi->enabled = true;

...


But if the IPG clock is disabled and enabled right after, the LCD
works fine.

The changes made in imxfb.c were:
...

clk_prepare_enable(fbi->clk_ipg);
clk_disable_unprepare(fbi->clk_ipg);
clk_prepare_enable(fbi->clk_ipg);

clk_prepare_enable(fbi->clk_ahb);
clk_prepare_enable(fbi->clk_per);
fbi->enabled = true;

...

It was suggested by Fabio that this could be caused by a wrong clock
reference count which prevented the IPG fb clock to be enabled, but
I've checked in debugfs, and both enable_cnt  and prepare_cnt seem OK
for all three FB clocks.

So, I'm really stuck here. Any hints would be greatly appreciated.

Thanks,
Carlos Soto

2015-02-21 16:18 GMT+01:00 Fabio Estevam [off-list ref]:

Hi,

Carlos Soto uses a Karo mx25 and he noticed that the LCD only works if we do:

echo 1 > /sys/class/graphics/fb0/blank
echo 0 > /sys/class/graphics/fb0/blank

I can confirm the same on mx25pdk running 3.19 [1], but I could not
understand why the display does not start turned on by default.

[1] http://www.spinics.net/lists/arm-kernel/msg399949.html

Any ideas?

Thanks,

Fabio Estevam