@@ -7,6 +7,11 @@ this device needs phandles to the AUXADC. Also it controls a mux in the
 apmixedsys register space via AHB bus accesses, so a phandle to the APMIXEDSYS
 is also needed.
 
+There is another hardware engine, SVS (Smart Voltage Scaling) which shares the
+same block of banked registers with Mediatek thermal controller. Hence the
+driver of SVS is integrated with the driver of Mediatek thermal controller. The
+properties required by SVS engine are optional for Mediatek thermal controller.
+
 Required properties:
 - compatible: "mediatek,mt8173-thermal"
 - reg: Address range of the thermal controller

@@ -21,9 +26,15 @@ Required properties:
 - #thermal-sensor-cells : Should be 0. See ./thermal.txt for a description.
 
 Optional properties:
-- nvmem-cells: A phandle to the calibration data provided by a nvmem device. If
-               unspecified default values shall be used.
-- nvmem-cell-names: Should be "calibration-data"
+- clocks, clock-names: Clocks that are optional for the thermal controller.
+	       Specify to enable SVS engine.
+	       "svs_pll": The PLL clock should be switched to during
+			  initialization stage of SVS engine.
+	       "svs_mux": The MUX clock controls the clock input of SVS engine.
+- nvmem-cells: A list of phandles to the calibration data provided by a nvmem
+	       device. If unspecified default values shall be used. The SVS
+	       engine will be disabled if no SVS calibration data is specified.
+- nvmem-cell-names: Should be "calibration-data" and "svs-calibration-data"
 
 Example:
 

@@ -33,11 +44,11 @@ Example:
 		reg = <0 0x1100b000 0 0x1000>;
 		interrupts = <0 70 IRQ_TYPE_LEVEL_LOW>;
 		clocks = <&pericfg CLK_PERI_THERM>, <&pericfg CLK_PERI_AUXADC>;
-		clock-names = "therm", "auxadc";
+		clock-names = "therm", "auxadc", ;
 		resets = <&pericfg MT8173_PERI_THERM_SW_RST>;
 		reset-names = "therm";
 		mediatek,auxadc = <&auxadc>;
 		mediatek,apmixedsys = <&apmixedsys>;
-		nvmem-cells = <&thermal_calibration_data>;
-		nvmem-cell-names = "calibration-data";
+		nvmem-cells = <&thermal_calibration_data>, <&svs-calibration>;
+		nvmem-cell-names = "calibration-data", "svs-calibration-data";
 	};