[PATCH v4 1/5] dt-bindings: add SMP enable-method for Broadcom NSP

On 02/12/15 08:06, Kapil Hali wrote:

quoted

quoted

--- /dev/null
+++ b/Documentation/devicetree/bindings/arm/bcm/brcm,nsp-cpu-method.txt

@@ -0,0 +1,39 @@
+Broadcom Northstar Plus SoC CPU Enable Method
+---------------------------------------------
+This binding defines the enable method used for starting secondary
+CPUs in the following Broadcom SoCs:
+  BCM58522, BCM58525, BCM58535, BCM58622, BCM58623, BCM58625, BCM88312
+
+The enable method is specified by defining the following required
+properties in the "cpus" device tree node:
+  - enable-method = "brcm,bcm-nsp-smp";
+  - secondary-boot-reg = <...>;

Both of these are supposed to be per cpu core.

'enable-method' if not found in 'cpu' node is looked at in the 'cpus' 
node. Except for two-three SoC families, 'enable-method' is within 
'cpus' node. Is my interpretation incorrect? Did I miss anything here?

So, what do we do from here? I would appreciate a timely answer from the
DT maintainers here so we can decide on the fate of this patch series
for 4.5.

Thank you
-- 
Florian