T Tyler Baker #
Message details and related content
On 30 September 2015 at 12:18, Mark Brown [off-list ref] wrote:
On Wed, Sep 30, 2015 at 11:12:58AM -0700, Tyler Baker wrote:quoted
On 30 September 2015 at 10:31, Mark Brown [off-list ref] wrote:quoted
+ Peter as he has been submitting u-boot patches recently for the HiKey.quoted
Obviously, both UEFI and u-boot can be configured to use either UART, and at the moment u-boot defaults to using the on board UART. Whereas UEFI is using UART1 on the LS connector. I'm fine with switching the console default to use the UART1 on the LS connector as long as there is agreement to do so.Given that UEFI is switching and the requirement for soldering to get to the on board UART it does seem to make sense, though it will create some pain for current users.quoted
quoted
While we're at it there was a recent talk which mentioned a fairly large amount of functionality that's apparently already "upstream" for this device but not included in the DT, assuming that means that driver support is there it would be good to add the corresponding DT.quoted
Indeed, I think this comment is targeted to toward the d410c though as there are drivers for eMMC, and microsd drivers upstream but no DT bindings. I do not believe currently this is the case for HiKey.My understanding is that it applies to both with slightly different driver sets, the slides aren't online yet (!) but if you look at 10:52 or so in the video we should have SD/eMMC on HiKey in v4.1 with thermal and CPUfreq added in v4.2. It also looks like there's just some DT additions needed to enable reset, cpuidle and CPU hotplug using generic code (mainly the constants for PSCI I expect).
I just skimmed the video and I see your point. I'll need to
investigate a bit but I'm up for sending some follow up patches to get
these drivers functioning. First lets get the UART working :)
Cheers,
Tyler