On Wednesday 02 September 2015 12:34 PM, Jisheng Zhang wrote:

On Wed, 2 Sep 2015 01:02:17 +0530
Vaibhav Hiremath [off-list ref] wrote:

quoted

Currently, the sdhci_do_start_signal_voltage_switch() function invokes
controller specific voltage switch configuration only for 1.8v usecase;
but it is required for others as well.

For example, in case of PXA1928 SDH controller, we need to set different
configuration for 3.3, 1.8 and 1.2 volt support (I/O domain power
control register).

Signed-off-by: Vaibhav Hiremath <redacted>
---
Note:
Currently ->voltage_switch() callback is only supported
in f_sdh30 driver. And I am not sure on the dependency of execution
sequence for that device. I could have moved ->voltage_switch() call
at one common place (above/below), but was not quite sure about it.
So, replicated/duplicated the call for other voltages.

  drivers/mmc/host/sdhci.c | 8 ++++++++
  1 file changed, 8 insertions(+)

diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index 3dd295f..b59b76d 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c

@@ -1753,6 +1753,10 @@ static int sdhci_do_start_signal_voltage_switch(struct sdhci_host *host,
  		/* Wait for 5ms */
  		usleep_range(5000, 5500);

+		/* Some controller need to do more when switching */
+		if (host->ops->voltage_switch)
+			host->ops->voltage_switch(host, MMC_SIGNAL_VOLTAGE_330);

Could this be implemented by regulator API? From patch set 3/3, the pxa1928
voltage_switch hook is to operate the IO pad registers, this seems not belong
to the SDHC IP core.

Not quite sure whether regulator would be right fit for this.

Initially I was thinking of making use of pinconf framework, using
PIN_CONFIG_POWER_SOURCE, but that too I am not sure is the right way of
doing it.

Probably, question for pinctrl maintainer. Looping Linus Walleji.

Also note that, this configuration is not applicable to all pins/pads,
only handpicked pads have this configuration (voltage selection on
pads).
And this configuration is not part of the same register map.

It is part of separate register map (AIB_EXT_REG_BASE), called IO
domain power control register.
And that

Thanks,
Vaibhav