[PATCH v3 04/10] Doc: usb: ci-hdrc-usb2: add ahb-burst-config for binding doc
From: Peter Chen <hidden>
Date: 2015-08-07 07:15:41
Also in:
linux-devicetree
Subsystem:
open firmware and flattened device tree bindings, the rest, usb subsystem · Maintainers:
Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds, Greg Kroah-Hartman
It is used to change ahb burst configuration for platforms, it is vendor specific. Signed-off-by: Peter Chen <redacted> --- Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt | 7 +++++++ 1 file changed, 7 insertions(+)
diff --git a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
index 4159c8c..d52a747 100644
--- a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
+++ b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt@@ -32,6 +32,11 @@ Optional properties: - external-vbus-divider: (FSL only) enables off-chip resistor divider for Vbus - itc-setting: interrupt threshold control register control, the setting should be aligned with ITC bits at register USBCMD. +- ahb-burst-config: it is vendor dependent, the required value should be + aligned with AHBBRST at SBUSCFG, the range is from 0x0 to 0x7. This + property is used to change AHB burst configuration, check the chipidea + spec for meaning of each value. If this property is not existed, it + will use the reset value. Example:
@@ -44,4 +49,6 @@ Example: phy-names = "usb-phy"; vbus-supply = <®_usb0_vbus>; gadget-itc-setting = <0x4>; /* 4 micro-frames */ + /* Incremental burst of unspecified length */ + ahb-burst-config = <0x0>; };
--
1.9.1