[PATCH v5 2/5] PCI: designware: Add ARM64 support

-----Original Message-----
From: James Morse [mailto:james.morse at arm.com]
Sent: Tuesday, August 04, 2015 11:40 AM
To: Gabriele Paoloni; Wangzhou (B)
Cc: Bjorn Helgaas; Jingoo Han; Pratyush Anand; Arnd Bergmann; Lorenzo
Pieralisi; Liviu Dudau; thomas.petazzoni at free-electrons.com; Jason
Cooper; robh at kernel.org; linux-pci at vger.kernel.org; linux-arm-
kernel at lists.infradead.org; devicetree at vger.kernel.org; Yuanzhichang;
Zhudacai; zhangjukuo; qiuzhenfa; liudongdong (C); qiujiang;
Kangfenglong; Liguozhu (Kenneth)
Subject: Re: [PATCH v5 2/5] PCI: designware: Add ARM64 support

On 04/08/15 11:23, Gabriele Paoloni wrote:

quoted

Hi James

Please see "[PATCH v6] PCI: Store PCIe bus address in struct

of_pci_range"

quoted

I think if you apply this patch your problem should be solved...

If you follow the discussion you see that this patch is going to be

part

quoted

of the next designware patchset...

Yes I just spotted that series after continuing through my email
backlog.

quoted

Wang Zhou said "You need apply Gabriele's patch before applying this

patch."

quoted

but he didn't specify which one and obviously this patch should have

been part

quoted

of the patch-set

I assumed he meant your patch 1 in the same series, (given the reply
was to
patch 2).

With the '[PATCH v6] PCI: Store PCIe bus address in struct
of_pci_range'
applied before patches and 1 and 2 of this series - pcie on the
'Freescale i.MX6 Quad SABRE Lite Board' works fine.

I can rescan the bus, load firmware, list nearby APs, and even get MSIs
coming from the card.

This is Great NEWS! Thanks a Lot!

Tested-by: James Morse <james.morse@arm.com>



James