On 6 August 2015 at 18:14, Geert Uytterhoeven [off-list ref] wrote:

On Thu, Aug 6, 2015 at 3:51 PM, Russell King - ARM Linux
[off-list ref] wrote:

quoted

On Thu, Aug 06, 2015 at 05:55:23PM +0530, Vignesh R wrote:

quoted

On the whole following are my requirements:
1. to be able to communicate with non -flash SPI devices via config port
( this functionality is supported by current driver, I dont want to
break it). Or pump any spi_message on to SPI bus directly.
2. take advantage of memory mapped port in order to increase read
throughput( and use dma in future) when the slave is a m25p80 type flash.
3. handle m25p80 as well as other slave on multiple chipselects.

I just need to know whether the user that requested the transfer is
m25p80 driver. If yes, ti-qspi driver can take advantage of memory
mapped interface, else just use config port to access SPI bus directly.

The problem with this approach is that it's an abomination.  It's adding
a SPI-user specific hack which is detected by a specific driver.  That's
really not sane - what happens when we have lots of these kinds of "I'm
an X SPI-user" with drivers detecting that?  It's not maintainable in the
long term.

Yes, your requirements _today_ seem simple and easy, but you're only
thinking about today, not tomorrow when you've moved on and someone else
has to maintain the mess left behind (or delete it from mainline because
they're sick of dealing with a hack.)

quoted

The spi_message that is received in transfer_one_message() is too
generic to imply the slave device that is on the other side of the wire.
IMO, the read command does not imply that the slave is m25p80 flash
(besides the read opcodes vary across vendors of m25p80 and across modes).

I can see both sides of the argument.

Mark is saying: if the SPI driver detects that the message to be transmitted
is a read command followed by the appropriate number of dummy bytes, and
then the data being read _and_ it's using quad-mode access, and the hardware
generates _exactly_ that in hardware using the memory mapped mode, there is
no reason _not_ to use the hardware to achieve that SPI transaction.  The
bus activity will be identical to what happens when the SPI controller is
used manually to achieve that bus sequence.

You're saying: but the documentation says you can't use it for anything
except m25p80.  If you look at 24.5.4.1.2, it tells you what the SFI
generates on the bus, which is:

1. CS active
2. Read command byte sent
3. 1-4 address bytes sent
4. 0-3 dummy bytes sent
5. data bytes read from bus
6. CS inactive

So, Mark's point is "if we can detect a transaction which fits _that_
bus activity, there's no reason not to use this acceleration for the
transaction."

What you're failing to counter with is: we don't have enough information
in the SPI driver to know how many dummy bytes there are between the
address bytes and the data read from the bus.

Irrespective of the dummy bytes.
What if the spi device is not a FLASH ROM, but some other device,
which receives a data packet that accidentally looks like an m25p80 READ
command?

Presumably the driver would interpret some random part of the message
as address and map the reply in your address space at that address
from the flash mmap base.

If you happen to overflow the flash memory mmap space the behaviour
will probably not be well defined.

Thanks

Michal