[PATCH RFC 0/4] PL08x DT bindings and LPC18xx DMA support

On Sun, Jun 14, 2015 at 1:22 PM, Joachim Eastwood [off-list ref] wrote:

This patch set aims to add support for DMA on the NXP LPC18xx/43xx
(Cortex-M3/M4) platform. The platform has a PL080 controller with a
mux in front of the DMA request lines. This setup is quite common
and can be found on most other, if not all, NXP LPC devices.

Nice!

 - remove channel sub-nodes from driver and dt doc.

Why? It was a good approach for the Nomadik. Well I'll look
how you do it for NXP, I guess it makes total sense for you.

N?ras,
Linus Walleij