[PATCH 1/2] spi: dw: Allow interface drivers to limit data I/O to word sizes
From: andriy.shevchenko@linux.intel.com (Andy Shevchenko)
Date: 2015-06-24 11:57:44
Also in:
linux-devicetree, linux-spi
On Fri, 2015-06-19 at 10:43 +0200, Michael van der Westhuizen wrote:
The commit dd11444327ce ("spi: dw-spi: Convert 16bit accesses to
32bit
accesses") changed all 16bit accesses in the DW_apb_ssi driver to
32bit.
This, unfortunately, breaks data register access on picoXcell, where
the
DW IP needs data register accesses to be word accesses (all other
accesses appear to be OK).Thanks for the patch. My comments below.
This change introduces a new master variable to allow interface drivers to specify that 16bit data transfer I/O is required. This change also introduces the ability to set this variable via device tree bindings in the MMIO interface driver. Before this change, on a picoXcell pc3x3: spi_master spi32766: interrupt_transfer: fifo overrun/underrun m25p80 spi32766.0: error -5 reading 9f m25p80: probe of spi32766.0 failed with error -5 After this change: m25p80 spi32766.0: m25p40 (512 Kbytes)
Please, add Fixes: tag as well.
quoted hunk
Signed-off-by: Michael van der Westhuizen <redacted> --- drivers/spi/spi-dw-mmio.c | 5 +++++ drivers/spi/spi-dw.c | 13 +++++++++++-- drivers/spi/spi-dw.h | 11 +++++++++++ 3 files changed, 27 insertions(+), 2 deletions(-)diff --git a/drivers/spi/spi-dw-mmio.c b/drivers/spi/spi-dw-mmio.c index eb03e12..1397424 100644 --- a/drivers/spi/spi-dw-mmio.c +++ b/drivers/spi/spi-dw-mmio.c@@ -74,6 +74,11 @@ static int dw_spi_mmio_probe(structplatform_device *pdev) dws->max_freq = clk_get_rate(dwsmmio->clk); + if (pdev->dev.of_node) + dws->data_io_16bit =
I don't like "flexibility" in the DeviceTree data base and thus I would prefer to see what we already have in naming there, i.e. reg-io-width = 2 or 4.
quoted hunk
+ of_property_read_bool(pdev->dev.of_node, + "snps,data-io-16bit"); + num_cs = 4; if (pdev->dev.of_node)diff --git a/drivers/spi/spi-dw.c b/drivers/spi/spi-dw.c index 8d67d03..862b001 100644 --- a/drivers/spi/spi-dw.c +++ b/drivers/spi/spi-dw.c@@ -194,7 +194,12 @@ static void dw_writer(struct dw_spi *dws) else txw = *(u16 *)(dws->tx); } - dw_writel(dws, DW_SPI_DR, txw); + + if (dws->data_io_16bit) + dw_writew(dws, DW_SPI_DR, txw); + else + dw_writel(dws, DW_SPI_DR, txw); + dws->tx += dws->n_bytes; } }@@ -205,7 +210,11 @@ static void dw_reader(struct dw_spi *dws) u16 rxw; while (max--) { - rxw = dw_readl(dws, DW_SPI_DR); + if (dws->data_io_16bit) + rxw = dw_readw(dws, DW_SPI_DR); + else + rxw = dw_readl(dws, DW_SPI_DR); + /* Care rx only if the transfer's original "rx" isnot null */ if (dws->rx_end - dws->len) { if (dws->n_bytes == 1)diff --git a/drivers/spi/spi-dw.h b/drivers/spi/spi-dw.h index 6c91391..ced276a 100644 --- a/drivers/spi/spi-dw.h +++ b/drivers/spi/spi-dw.h@@ -109,6 +109,7 @@ struct dw_spi { u32 fifo_len; /* depth of the FIFObuffer */ u32 max_freq; /* max bus freq supported */ + bool data_io_16bit; /* DR is only 16 bits wide */ u16 bus_num; u16 num_cs; /* supported slave numbers */@@ -145,11 +146,21 @@ static inline u32 dw_readl(struct dw_spi *dws,u32 offset) return __raw_readl(dws->regs + offset); } +static inline u16 dw_readw(struct dw_spi *dws, u32 offset) +{ + return __raw_readw(dws->regs + offset); +} + static inline void dw_writel(struct dw_spi *dws, u32 offset, u32 val) { __raw_writel(val, dws->regs + offset); } +static inline void dw_writew(struct dw_spi *dws, u32 offset, u16 val) +{ + __raw_writew(val, dws->regs + offset); +} + static inline void spi_enable_chip(struct dw_spi *dws, int enable) { dw_writel(dws, DW_SPI_SSIENR, (enable ? 1 : 0));
Regarding to above comment what about something like
static inline u32 dw_read_reg(dws, offset)
{
switch (reg_io_width)
case 2:
return dw_readw();
case 4:
default:
return dw_readl();
}
--
Andy Shevchenko [off-list ref]
Intel Finland Oy