[PATCH v2] gpio/xilinx: Use correct address when setting initial values.

xgpio_save_regs() is used in this driver to setup the initial
values of the registers in the hardware.

The relevant registers at that time are:
0x0 -> channel 0 data (32 bits, one for each GPIO on this channel).
0x4 -> channel 0 tri, controls in/out status for each GPIO of this channel.
0x8 -> channel 1 data
0xC -> channel 1 tri

gpio-xilinx.c defines these:
XGPIO_DATA_OFFSET   (0x0)
XGPIO_TRI_OFFSET    (0x4)
XGPIO_CHANNEL_OFFSET	0x8

Before this patch, the "data" register value of channel 1 was written
at 0x4 intead of 0x8 (overwriting the channel 0 "tri" register),
and the "tri" register value for channel 1 was written at 0x8 instead of 0xC.

Signed-off-by: Rapha?l Teysseyre <redacted>
---
 drivers/gpio/gpio-xilinx.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpio/gpio-xilinx.c b/drivers/gpio/gpio-xilinx.c
index 61243d1..e544b7a 100644
--- a/drivers/gpio/gpio-xilinx.c
+++ b/drivers/gpio/gpio-xilinx.c

@@ -220,9 +220,9 @@ static void xgpio_save_regs(struct of_mm_gpio_chip *mm_gc)
 	if (!chip->gpio_width[1])
 		return;
 
-	xgpio_writereg(mm_gc->regs + XGPIO_DATA_OFFSET + XGPIO_TRI_OFFSET,
+	xgpio_writereg(mm_gc->regs + XGPIO_DATA_OFFSET + XGPIO_CHANNEL_OFFSET,
 		       chip->gpio_state[1]);
-	xgpio_writereg(mm_gc->regs + XGPIO_TRI_OFFSET + XGPIO_TRI_OFFSET,
+	xgpio_writereg(mm_gc->regs + XGPIO_TRI_OFFSET + XGPIO_CHANNEL_OFFSET,
 		       chip->gpio_dir[1]);
 }
 

-- 
1.7.1