Thread (27 messages) 27 messages, 3 authors, 2015-09-14

[PATCH 0/7] soc: brcmstb: add system suspend support for STB SoCs

From: Gregory Fong <hidden>
Date: 2015-06-19 03:21:35
Also in: linux-devicetree, lkml

On Thu, Jun 18, 2015 at 5:11 PM, Brian Norris
[off-list ref] wrote:
Hi,

This patch set introduces system suspend/resume support for Broadcom STB SoCs.
There are two suspend modes (S2 and S3) as well as a related low-power shutdown
mode (S5).

Along with the core PM support, include a driver for the wakeup-timer, which
allows for simple testing of suspend/resume wakeup cycles.

Brian

Brian Norris (7):
  Documentation: dt: brcmstb: add system PM bindings
  Documentation: dt: brcmstb: add waketimer documentation
  soc: add stubs for brcmstb SoC's
  soc: brcmstb: add PM suspend/resume support (S2/S3/S5)
  soc: brcmstb: add wake-timer driver
  ARM: brcmstb: mask GIC IRQs on suspend
  ARM: dts: brcmstb: add BCM7445 system PM DT nodes
I tested this series two ways: with the device tree built into the
bootloader (BOLT) on BCM7445 and by using
arch/arm/boot/dts/bcm7445-bcm97445svmb.dtb

With the device tree from BOLT, everything works fine.  Tested the
waketimer for S2, S3, and S5.

With the device tree in arch/arm/boot/dts/bcm7445-bcm97445svmb.dts, S2
works, but S3 and S5 do not.  It comes back up but doesn't reach the
prompt:

[    6.050808] PM: suspend of devices complete after 1.425 msecs
[    6.051760] PM: late suspend of devices complete after 0.947 msecs
[    6.052535] PM: noirq suspend of devices complete after 0.770 msecs
[    6.052537] Disabling non-boot CPUs ...
[    6.053005] CPU1: shutdown
[    6.065914] CPU2: shutdown
[    6.080756] CPU3: shutdown
[    6.095214] Enabling non-boot CPUs ...
[    6.111496] CPU1 is up
[    6.126934] CPU2 is up
[    6.142511] CPU3 is up
[    6.145308] PM: noirq resume of devices complete after 2.772 msecs
[    6.148022] PM: early resume of devices complete after 2.626 msecs
[    6.151017] PM: resume of devices complete after 2.976 msecs
[    6.212771] Restarting tasks ... done.
[[[ output stops here ]]]

I suspect there might be an issue somewhere in
[PATCH 7/7] ARM: dts: brcmstb: add BCM7445 system PM DT nodes.
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help