[PATCH v2 01/11] dt-bindings: mediatek: Modify pinctrl bindings for mt6397.
From: Hongzhou Yang <hidden>
Date: 2015-05-19 06:12:07
Also in:
linux-devicetree, linux-gpio, linux-mediatek, lkml
Subsystem:
open firmware and flattened device tree bindings, pin control subsystem, the rest · Maintainers:
Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Walleij, Linus Torvalds
Since 6397 is no need to support interrupt controller, moving interrupt controller relate property to optional list. Also adding mt8173 and mt8127 to bindings. Signed-off-by: Hongzhou Yang <redacted> --- .../devicetree/bindings/pinctrl/pinctrl-mt65xx.txt | 9 +++++++-- 1 file changed, 7 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-mt65xx.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-mt65xx.txt
index 5868a0f..0480bc3 100644
--- a/Documentation/devicetree/bindings/pinctrl/pinctrl-mt65xx.txt
+++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-mt65xx.txt@@ -3,9 +3,11 @@ The Mediatek's Pin controller is used to control SoC pins. Required properties: -- compatible: value should be either of the following. +- compatible: value should be one of the following. (a) "mediatek,mt8135-pinctrl", compatible with mt8135 pinctrl. -- mediatek,pctl-regmap: Should be a phandle of the syscfg node. + (b) "mediatek,mt8173-pinctrl", compatible with mt8173 pinctrl. + (c) "mediatek,mt6397-pinctrl", compatible with mt6397 pinctrl. + (d) "mediatek,mt8127-pinctrl", compatible with mt8127 pinctrl. - pins-are-numbered: Specify the subnodes are using numbered pinmux to specify pins. - gpio-controller : Marks the device node as a gpio controller.
@@ -24,6 +26,9 @@ Required properties: Only the following flags are supported: 0 - GPIO_ACTIVE_HIGH 1 - GPIO_ACTIVE_LOW + +Optional properties: +- mediatek,pctl-regmap: Should be a phandle of the syscfg node. - reg: physicall address base for EINT registers - interrupt-controller: Marks the device node as an interrupt controller - #interrupt-cells: Should be two.
--
1.7.9.5