[PATCH v7 2/7] mailbox: arm_mhu: add driver for ARM MHU controller

Hi Vincent,

Forgot couple of things earlier:

On 04/03/15 11:01, Vincent Yang wrote:

From: Jassi Brar <redacted>

Add driver for the ARM Primecell Message-Handling-Unit(MHU) controller.

Signed-off-by: Jassi Brar <redacted>
Signed-off-by: Andy Green <redacted>
Signed-off-by: Vincent Yang <redacted>
Signed-off-by: Tetsuya Nuriya <redacted>
---
  .../devicetree/bindings/mailbox/arm-mhu.txt        |  43 +++++
  drivers/mailbox/Kconfig                            |   9 +
  drivers/mailbox/Makefile                           |   2 +
  drivers/mailbox/arm_mhu.c                          | 195 +++++++++++++++++++++
  4 files changed, 249 insertions(+)
  create mode 100644 Documentation/devicetree/bindings/mailbox/arm-mhu.txt
  create mode 100644 drivers/mailbox/arm_mhu.c

[...]

+static int mhu_send_data(struct mbox_chan *chan, void *data)
+{
+	struct mhu_link *mlink = chan->con_priv;
+	u32 *arg = data;
+

Arnd doesn't like this and had suggestions in some other thread.

+	writel_relaxed(*arg, mlink->tx_reg + INTR_SET_OFS);
+
+	return 0;
+}
+
+static int mhu_startup(struct mbox_chan *chan)
+{
+	struct mhu_link *mlink = chan->con_priv;
+	u32 val;
+	int ret;
+
+	val = readl_relaxed(mlink->tx_reg + INTR_STAT_OFS);
+	writel_relaxed(val, mlink->tx_reg + INTR_CLR_OFS);
+
+	ret = request_irq(mlink->irq, mhu_rx_interrupt,
+			  IRQF_SHARED, "mhu_link", chan);

Any reason we can't move this to probe and have {en,dis}able_irq here if
needed. I has seen it was too heavy to have these especially when
sending small packets.

Regards,
Sudeep