[Patch v3 1/2] dt/bindings: qcom_adm: Fix channel specifiers
From: Andy Gross <hidden>
Date: 2015-02-11 06:04:38
Also in:
linux-arm-msm, linux-devicetree, lkml
Subsystem:
arm/qualcomm mailing list, dma generic offload engine subsystem, open firmware and flattened device tree bindings, the rest · Maintainers:
Vinod Koul, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
This patch removes the crci information from the dma channel property. At least one client device requires using more than one CRCI value for a channel. This does not match the current binding and the crci information needs to be removed. Instead, the client device will provide this information via other means. Signed-off-by: Andy Gross <redacted> --- Documentation/devicetree/bindings/dma/qcom_adm.txt | 16 ++++++---------- 1 file changed, 6 insertions(+), 10 deletions(-)
diff --git a/Documentation/devicetree/bindings/dma/qcom_adm.txt b/Documentation/devicetree/bindings/dma/qcom_adm.txt
index 9bcab91..38d45f8 100644
--- a/Documentation/devicetree/bindings/dma/qcom_adm.txt
+++ b/Documentation/devicetree/bindings/dma/qcom_adm.txt@@ -4,8 +4,7 @@ Required properties: - compatible: must contain "qcom,adm" for IPQ/APQ8064 and MSM8960 - reg: Address range for DMA registers - interrupts: Should contain one interrupt shared by all channels -- #dma-cells: must be <2>. First cell denotes the channel number. Second cell - denotes CRCI (client rate control interface) flow control assignment. +- #dma-cells: must be <1>. First cell denotes the channel number. - clocks: Should contain the core clock and interface clock. - clock-names: Must contain "core" for the core clock and "iface" for the interface clock.
@@ -22,7 +21,7 @@ Example: compatible = "qcom,adm"; reg = <0x18300000 0x100000>; interrupts = <0 170 0>; - #dma-cells = <2>; + #dma-cells = <1>; clocks = <&gcc ADM0_CLK>, <&gcc ADM0_PBUS_CLK>; clock-names = "core", "iface";
@@ -35,15 +34,12 @@ Example: qcom,ee = <0>; }; -DMA clients must use the format descripted in the dma.txt file, using a three +DMA clients must use the format descripted in the dma.txt file, using a two cell specifier for each channel. -Each dmas request consists of 3 cells: +Each dmas request consists of two cells: 1. phandle pointing to the DMA controller 2. channel number - 3. CRCI assignment, if applicable. If no CRCI flow control is required, use 0. - The CRCI is used for flow control. It identifies the peripheral device that - is the source/destination for the transferred data. Example:
@@ -56,7 +52,7 @@ Example: cs-gpios = <&qcom_pinmux 20 0>; - dmas = <&adm_dma 6 9>, - <&adm_dma 5 10>; + dmas = <&adm_dma 6>, + <&adm_dma 5>; dma-names = "rx", "tx"; };
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation