[PATCH 1/6] soc: qcom: gsbi: Add support for ADM CRCI muxing
From: Stanimir Varbanov <hidden>
Date: 2015-01-28 20:54:25
Also in:
linux-arm-msm, linux-devicetree, lkml
Hi Andy, On 01/28/2015 12:10 AM, Andy Gross wrote:
This patch adds automatic configuration for the ADM CRCI muxing required to support DMA operations for GSBI clients. The GSBI mode and instance determine the correct TCSR ADM CRCI MUX value that must be programmed so that the DMA works properly. Signed-off-by: Andy Gross <redacted> --- .../devicetree/bindings/soc/qcom/qcom,gsbi.txt | 17 ++- drivers/soc/qcom/Kconfig | 1 + drivers/soc/qcom/qcom_gsbi.c | 148 +++++++++++++++++++- 3 files changed, 158 insertions(+), 8 deletions(-)
<snip>
quoted hunk ↗ jump to hunk
diff --git a/drivers/soc/qcom/Kconfig b/drivers/soc/qcom/Kconfig index 7bd2c94..32f20be 100644 --- a/drivers/soc/qcom/Kconfig +++ b/drivers/soc/qcom/Kconfig@@ -4,6 +4,7 @@ config QCOM_GSBI tristate "QCOM General Serial Bus Interface" depends on ARCH_QCOM + select MFD_SYSCON
Wrong indentation? In fact the original Kconfig entry has spaces instead of tabs, could you prepare a cleanup patch for this.
help
Say y here to enable GSBI support. The GSBI provides control
functions for connecting the underlying serial UART, SPI, and I2C<snip> -- regards, Stan