[PATCH v2 1/1] ARM: at91/dt: sam9x5: Add CAN device nodes
From: Alexandre Belloni <hidden>
Date: 2014-10-06 14:12:03
Also in:
linux-devicetree
Hi, On 02/10/2014 at 13:19:45 +0200, Alexander Stein wrote :
quoted hunk
Add the missing CAN devices node including their pin muxing and clocks. Signed-off-by: Alexander Stein <redacted> --- Changes in v2: * Adjusted pinmux comment arch/arm/boot/dts/at91sam9x5.dtsi | 48 +++++++++++++++++++++++++++++++++++++++ 1 file changed, 48 insertions(+)diff --git a/arch/arm/boot/dts/at91sam9x5.dtsi b/arch/arm/boot/dts/at91sam9x5.dtsi index e1a5c70..e3f11f2 100644 --- a/arch/arm/boot/dts/at91sam9x5.dtsi +++ b/arch/arm/boot/dts/at91sam9x5.dtsi@@ -763,6 +795,22 @@ }; }; + can0 { + pinctrl_can0_rx_tx: can0_rx_tx { + atmel,pins = + <AT91_PIOA 9 AT91_PERIPH_B AT91_PINCTRL_NONE /* CANRX, conflicts with DRXD */ + AT91_PIOA 10 AT91_PERIPH_B AT91_PINCTRL_NONE>; /* CANTX, conflicts with DTXD */
Last nitpick, could you make that be CANRX0 and CANTX0 ?
+ };
+ };
+
+ can1 {
+ pinctrl_can1_rx_tx: can1_rx_tx {
+ atmel,pins =
+ <AT91_PIOA 6 AT91_PERIPH_B AT91_PINCTRL_NONE /* CANRX, conflicts with RXD1 */
+ AT91_PIOA 5 AT91_PERIPH_B AT91_PINCTRL_NONE>; /* CANTX, conflicts with TXD1 */And CANRX1, CANTX1 here so that it is the same as the datasheet. Then you can add my acked-by. Thanks !
+ };
+ };
+
pioA: gpio at fffff400 {
compatible = "atmel,at91sam9x5-gpio", "atmel,at91rm9200-gpio";
reg = <0xfffff400 0x200>;
--
2.0.4
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel at lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel-- Alexandre Belloni, Free Electrons Embedded Linux, Kernel and Android engineering http://free-electrons.com