@@ -184,6 +184,7 @@ low-power-disable	- disable low power mode
 output-low		- set the pin to output mode with low level
 output-high		- set the pin to output mode with high level
 slew-rate		- set the slew rate
+io-standard		- set the IO standard
 
 For example:
 

@@ -215,5 +216,7 @@ arguments are described below.
 - input-debounce takes the debounce time in usec as argument
   or 0 to disable debouncing
 
+- io-standard takes a driver specific argument to select an IO standard
+
 More in-depth documentation on these parameters can be found in
 <include/linux/pinctrl/pinconfig-generic.h>

@@ -58,6 +58,7 @@ static struct pin_config_item conf_items[] = {
 	PCONFDUMP(PIN_CONFIG_SLEW_RATE, "slew rate", NULL, true),
 	PCONFDUMP(PIN_CONFIG_LOW_POWER_MODE, "pin low power", "mode", true),
 	PCONFDUMP(PIN_CONFIG_OUTPUT, "pin output", "level", true),
+	PCONFDUMP(PIN_CONFIG_IOSTANDARD, "io standard", NULL, true),
 };
 
 void pinconf_generic_dump_pin(struct pinctrl_dev *pctldev,

@@ -181,6 +182,7 @@ static struct pinconf_generic_dt_params dt_params[] = {
 	{ "output-low", PIN_CONFIG_OUTPUT, 0, },
 	{ "output-high", PIN_CONFIG_OUTPUT, 1, },
 	{ "slew-rate", PIN_CONFIG_SLEW_RATE, 0},
+	{ "io-standard", PIN_CONFIG_IOSTANDARD, 0},
 };
 
 /**

@@ -92,6 +92,9 @@
  * @PIN_CONFIG_END: this is the last enumerator for pin configurations, if
  *	you need to pass in custom configurations to the pin controller, use
  *	PIN_CONFIG_END+1 as the base offset.
+ * @PIN_CONFIG_IOSTANDARD: if the pin can select an IO standard, the argument to
+ *	this parameter (on a custom format) tells the driver which alternative
+ *	IO standard to use.
  */
 enum pin_config_param {
 	PIN_CONFIG_BIAS_DISABLE,

@@ -112,6 +115,7 @@ enum pin_config_param {
 	PIN_CONFIG_SLEW_RATE,
 	PIN_CONFIG_LOW_POWER_MODE,
 	PIN_CONFIG_OUTPUT,
+	PIN_CONFIG_IOSTANDARD,
 	PIN_CONFIG_END = 0x7FFF,
 };