[PATCHv3 1/6] ARM: dts: Add SoC level device tree support for LS1021A

-----Original Message-----
From: Arnd Bergmann [mailto:arnd at arndb.de]
Sent: Tuesday, September 09, 2014 7:50 PM
To: linux-arm-kernel at lists.infradead.org
Cc: Lu Jingchang-B35083; Guo Shawn-R65073; devicetree at vger.kernel.org;
Zhao Chenhui-B35336; Fu Chao-B44548; Leekha Shaveta-B20052; Gupta Suresh-
B42813; Sharma Bhupesh-B45370; Xiubo Li-B47053; Gupta Ruchika-R66431; Lu
Jingchang-B35083; Badola Nikhil-B46172
Subject: Re: [PATCHv3 1/6] ARM: dts: Add SoC level device tree support for
LS1021A

On Tuesday 09 September 2014 17:12:27 Jingchang Lu wrote:

quoted

+		dcfg: dcfg at 1ee0000 {
+			compatible = "fsl,ls1021a-dcfg";
+			reg = <0x0 0x1ee0000 0x0 0x10000>;
+		};
+		scfg: scfg at 1570000 {
+			compatible = "fsl,ls1021a-scfg";
+			reg = <0x0 0x1570000 0x0 0x10000>;
+		};

Should these be marked as 'compatible = "syscon"' as well?

Yes, some driver may reference them by the syscon driver, 
I will add the "syscon" compatible for driver has another reference way, thanks.

quoted

+	dcsr {
+		#address-cells = <1>;
+		#size-cells = <1>;
+		compatible = "fsl,dcsr", "simple-bus";
+
+		ranges = <0x0 0x0 0x20000000 0x1000000>;
+
+		dcsr-epu at 0 {
+			compatible = "fsl,ls1021a-dcsr-epu";
+			reg = <0x0 0x10000>;
+		};

The binding document only specifies a generic "fsl,dcsr-epu", not
"fsl,ls1021a-dcsr-epu". It also mandates that "interrupts"
must be present and contain three interrupt lines.

Please fix either the DT or the binding, so they match.

quoted

+		dcsr-gdi at 100000 {
+			compatible = "fsl,ls1021a-dcsr-gdi";
+			reg = <0x100000 0x10000>;
+		};
+
+		dcsr-dddi at 120000 {
+			compatible = "fsl,ls1021a-dcsr-dddi";
+			reg = <0x120000 0x10000>;
+		};
+
+		dcsr-dcfg at 220000 {
+			compatible = "fsl,ls1021a-dcsr-dcfg";
+			reg = <0x220000 0x1000>;
+		};
+
+		dcsr-clock at 221000 {
+			compatible = "fsl,ls1021a-dcsr-clock";
+			reg = <0x221000 0x1000>;
+		};

None of these are part of the dcsr.txt binding.

quoted

+		dcsr-rcpm at 222000 {
+			compatible = "fsl,ls1021a-dcsr-rcpm";
+			reg = <0x222000 0x1000 0x223000 0x1000>;
+		};

Missing generic fsl,dcsr-rcpm compatible value again.

quoted

+		dcsr-ccp at 225000 {
+			compatible = "fsl,ls1021a-dcsr-ccp";
+			reg = <0x225000 0x1000>;
+		};

I'm not checking any devices below this one, I assume they are mostly
incomplete, so please go through the whole list and make sure they all
match the documentation.
I can't really find any code using the dcsr in Linux. Is there an out of
tree driver that you plan to submit?

Arnd

I will remove these dcsr related nodes and leave them to be added later when
All ok. Thanks.


Best Regards,
Jingchang